User manual PIONEER DEH-2000MPB

[. . . ] -- it may cause injury to a passenger as a result of a sudden stop. Install this unit away from hot places such as near the heater outlet. [. . . ] When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. 6 Cap (1*) Do not remove cap if this terminal is not in use. In another type of vehicle, never connect 6* and 7*. 12 ISO connector In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. 13 Speaker leads White: Front left White/black: Front left Gray: Front right Gray/black: Front right Green: Rear left Green/black: Rear left Violet: Rear right Violet/black: Rear right Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. -- Place all cables away from moving parts, such as gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. -- Do not pass the yellow cable through a hole into the engine compartment to connect to a battery. -- Cover any disconnected cable connectors with insulating tape. [. . . ] 13 Speaker leads White: Front left + White/black: Front left * Gray: Front right + Gray/black: Front right * Green: Rear left + Green/black: Rear left * Violet: Rear right + Violet/black: Rear right * 14 Wired remote input Hard-wired remote control adaptor can be connected (sold separately). 15 Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. [. . . ]