User manual PIONEER DEH-6350SD

[. . . ] Before You Start About this unit 2 Demo mode 2 In case of trouble 2 About this manual 3 Operating this unit Head unit 3 Remote control 3 Display indication 4 Basic Operations 4 Use and care of the remote control 4 Menu operations identical for function settings/audio adjustments/initial settings/lists 5 Tuner 5 CD/CD-R/CD-RW and external storage devices (USB, SD) 6 iPod 6 Audio Adjustments 8 Initial Settings 9 Other Functions 10 Installation Connections Installation Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] The tuning step remains at 50 kHz during manual tuning. AM STEP (AM tuning step) The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. -- Place all cables away from hot places, such as near the heater outlet. -- Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. -- Cover any disconnected cable connectors with insulating tape. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. Turning the clock display on or off % Press /DISP OFF to turn the clock display on or off. # The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds. Turning the display off and on % Press /DISP OFF and hold until the display turns off and on. # Even if the display indication is turned off, operation can be conducted. If operation is conducted while the display indication is off, display will light up for a few seconds and then turn off again. Other devices (Another electronic device in the car) Metal parts of car's body When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. Use this unit with a 12-volt battery and negative grounding only. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in battery drain or a malfunction. Perform these connections when using a subwoofer without the optional amplifier. J When using a subwoofer of 70 W (2 ), be sure to connect the subwoofer to the violet and violet/black leads of this unit. Do not connect anything to the green and green/ black leads. [. . . ] ) Playable folders: up to 99 Playable files: up to 999 File system: ISO 9660 Level 1 and 2, Romeo, Joliet Multi-session playback: Compatible Packet write data transfer: Not compatible Regardless of the length of blank sections between the songs from the original recording, compressed audio discs play with a short pause between songs. Pioneer accepts no responsibility for data lost on USB memory/USB portable audio players/SD memory cards/SDHC memory cards, even if that data is lost while this unit is used. This unit supports only the following iPod models. supported iPod software versions are shown below. [. . . ]