User manual PIONEER DJM-700

[. . . ] Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory K015 En drawings. [. . . ] When manual filter is selected, the button indicator does not light. B, MASTER) Use to select the channel to which effects are applied (P. When [MIC] is selected, effects are applied to both microphone 1 and microphone 2. 41 Effect parameter 1 dial [TIME (PARAMETER 1)] Adjusts time parameter for selected effect (P. 18, 20) (With some effects, this is used for adjustments other than time parameters. ) · If the TIME dial is rotated while depressing the TAP button, direct BPM can be set manually. If the TIME dial is rotated while holding the TAP button and AUTO/TAP buttons depressed, the BPM can be set in 0. When power is first turned ON, defaults to effect OFF. when set to effect OFF , the button indicator lights. When effects are enabled (ON), the button flashes. Also, when one of the change operations is performed as noted in the table, the corresponding characters are displayed for two seconds, after which the display returns to the original effect name. 3 Parameter display section AUTO/TAP: [AUTO] lights when the BPM measuring mode is set to AUTO, and [TAP] lights when the BPM measuring mode is set to manual (TAP). Not lighted when MIDI output function is OFF. parameter 1 display (5 digits): Displays parameters designated for each effect. When the beat select buttons (BEAT , ) are pressed, the corresponding beat multiple change is displayed for two seconds. If the beat select buttons (BEAT , ) are used to designate a value outside the parameter range, the current number will flash but will not change. Unit Display (%/ms): Lights in accordance with the unit used for each effect. When the parameter 1 is between threshold values, the Although the display includes seven actual indicators, the values of the two ends can also be considered to represent indicators, with the result that nine positions can be logically assumed. When the values are at the two ends, no indicators light. When the MONO/STEREO switch is set to [MONO], the master output becomes a monaural combination of L+R channels. When the switch is set to [TALK OVER], any time a sound of over ­15 dB is detected by the microphone, the output for all sound sources other than the microphone are attenuated by 20 dB. Use the MIC 1 LEVEL dial to adjust the sound volume of MIC 1, and use the MIC 2 LEVEL dial to adjust the sound volume of MIC 2. [. . . ] Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check the points below. Sometimes the trouble may originate from another component. thus , also check the other electrical appliances also in use. [. . . ]