User manual PIONEER DRM-1004V40

[. . . ] Set the line voltage selector switch to the position of your area before connecting the power cord. The export of this product from Japan is regulated by the Japanese government. The export of this product may be prohibited without governmental license. To export or reexport of this product from a country other than Japan may also be prohibited without a license from that country. [. . . ] As the Changer detects the presence of disc with optical detection of the position at about 5 mm(3/16 in) inside the external periphery of the 12 cm(5 in) disc, the use of a disc which is transparent at the corresponding position or a 8 cm(3 in) disc may lead to disc detection error and to the disc damage in the worst case. For safety, this unit has been designed so that the door cannot be opened while the built-in reader or writer is operating. Since the disc rotates at a high speed in the built-in reader, vibrations or noise may be generated as a result. Note that this is not a malfunction and that it will not exert adverse effects on the performance of the unit. However, sound quality may decline, since such contamination diminishes the intensity of the light reflected from the signal side. When you clean a disc, use a soft cloth and carefully wipe towards outer edge of the disc. In case this Changer ON OFF is the last component, set this switch to the ON position. 1: When components are connected through the SCSI connection, the terminator should be attached to the last component in the connection. In case this drive is the last component, set this switch to the ON position. 2: Data block size switching between 512 (OFF) bytes j 2048 (ON) bytes. Assign a unique SCSI ID to each unit when several units are used on a same SCSI bus (in a daisy chain). Assign the ID number of the component connected 4 through the SCSI. Be careful to never assign the same number to more than one component. If an identical 0 number is assigned to more than one component, system operation will be impossible. NOTE: When setting the SCSI IDs, be careful not to leave the pointer arrow of the SCSI ID switch between two figures; be sure to set the switch so that the arrow points a single figure. With the DRM-1004V40, set the five SCSI ID switches to different positions. Before making or changing the connections, switch off the power switch and disconnect the power cord from the AC outlet. With this unit, each of the drives and Changer mechanism controller is equipped with a special SCSI controller and a couple of external SCSI connectors. This makes it possible to connect them with free SCSI wiring according to the user's operating environment and to control each drive and Changer independently. Caution in connection: Make sure that the SCSI ID and terminator of each drive have been set properly With the DRM-1004V40 When daisy chain connection is used, connect the drives and Changer so that the Changer becomes the terminating device, set the terminator SW of each drive to OFF, set that of the Changer to ON, and assign SCSI IDs so that they are not overlapped. NOTE: When setting the SCSI IDs, be careful not to leave the pointer arrow of the SCSI ID switch between two figures; be sure to set the switch so that the arrow points a single figure. When connecting each drive or chain individually to a SCSI controller, set all of the terminator SWs to ON. [. . . ] The disc cannot be exchanged from the control panel. The unit cannot be operated from the host computer. After taking action according to the remedies above, switch the power of the unit OFF then ON again. If the error code is displayed or the normal operation cannot be recovered still after this, immediately switch the power OFF again and call a PIONEER after-sale servicing agent or your dealer. [. . . ]