User manual PIONEER DRM-PW701

[. . . ] If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. [. . . ] You shouldn't have any problems using this with most SACD discs, but if the sound distorts, it is best to switch the gain setting back to 0 dB. The HDMI Audio setting cannot be switched while performing synchronized amp mode operations. The synchronized amp mode must be turned on in order to play the receiver's HDMI audio and video input signals from the TV with the receiver's power in the standby mode. This feature is only available when the connected display supports the automatic audio/video synchronizing capability (`lipsync') for HDMI. For more details about the lipsync feature of your display, contact the manufacturer directly. You can't use the Virtual Surround Back mode when the headphones are connected to this receiver or when any of the stereo, Front Stage Surround Advance or Stream Direct modes is selected. You can only use the Virtual Surround Back mode if the surround speakers are on and the SB setting is set to NO or if Front Bi-Amp or ZONE 2 is selected at Speaker System. The Virtual Surround Back mode cannot be applied to sources that do not have surround channel information (only when listening in some formats of Dolby TrueHD, DTS-HD or DTS Express mode). You can't use the Virtual Front Height mode when the headphones are connected to this receiver or when any of the stereo, Front Stage Surround Advance or Stream Direct modes is selected. You can only use the Virtual Front Height mode if the surround speakers are on. The Virtual Front Height mode cannot be applied to sources that do not have surround channel information (only when listening in some formats of Dolby TrueHD, DTS-HD or DTS Express mode). If the image doesn't match your monitor type, adjust the aspect ratio on the source component or on the monitor. This cannot be set when the resolution is set to PURE. The NORMAL setting is only displayed when 480i/p or 576i/p analog video signals are being input. This setting is only displayed when 480i or 576i analog video signals are being input. If the picture does not display properly when ON is selected, select AUTO or OFF. This setting is not valid for HDMI output. This setting is not displayed for component inputs. If you selected Speaker B at Speaker system setting on page 102, you can switch between speakers using the SPEAKERS button. If you selected Normal(SB/FH), Normal(SB/FW), Front Bi-Amp or ZONE 2, the button will simply switch your main speaker terminals on or off. Use SPEAKERS on the front panel to select a speaker terminal setting. As mentioned above, if you have selected Normal(SB/FH) or Normal(SB/FW), the button will simply switch your main speaker terminals (A) on or off. [. . . ] If the power cannot be turned off, press and hold STANDBY/ON on the front panel for over 10 seconds. (In this case, the various settings made on the receiver may be cleared. "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. "Works with iPhone" means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. [. . . ]