User manual PIONEER DVD-R7211

[. . . ] However the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To prevent a fire or shock hazard, do not place any container filed with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain D3-4-2-1-3_A_En or moisture. This product equipped with a three-wire grounding (earthed) plug - a plug that has a third (grounding) pin. [. . . ] ¶ If the selected memory bank already has a video memory setting stored in it, the previous contents will be erased (overwritten). If any other button is used to exit the setting menu, the newly set contents will not be stored. Enabled when using video materials and adjusted for moving or still images. Adjustments are possible only when progressive scan signals are output, but settings are disabled when setting is set to [ON]. White Level Use to adjust the image's white level. Effective when viewing animations and other images with broad areas of solid color. Chroma Delay Use to adjust imbalance between luminance (Y) signals and color (C) signals (effective only with progressive-scan images). HDMI Color Adjust (when connected to HDMI display device) When connected to a HDMI display device, with [Resolution] is set other than [VGA] (720 x 480), this allows the selection of HDMI output color. Film material: Movies are recorded at 24 fps (24 Hz); when this "PureCinema" mode is used to convert the original 24 fps recording to 60 fps progressive scan, the processing information recorded in the disc is used to produce the same scanning rate as the original movie, thus allowing you to enjoy extremely stable, flicker free images. The default setting is [Auto1], but if the picture appears to flicker or to produce rough contours, change the setting to [Auto2], [Off] or [On] as appropriate. When playing back DVD movie software originally recorded as 24 fps "film material, " you can see whether the disc is film or video material by displaying the video transmission rate on the disc information screen; if a hash mark (#) appears next to the transmission rate display [Tr. Set to select whether automatic playback is performed when power is turned ON. When connecting to a PC using a commercial 9-pin crosswired cable. It is necessary to set the title and chapter to be played at power on. Baud rate can be set to either 4800 (default), 9600, or 19200 bps. Use to set the mode during DVD reverse playback. When a NAVI command ("Return to menu", "Search for specific title", "Playback from beginning of title", etc. ) follows a title , the specified operation is performed after the title finishes playing. When no command is specified, playback stops. When playback of a single DVD disc title is complete, the next title plays and so on until all titles have played. The Key Lock function determines whether main unit or remote control unit buttons are "enabled" or "disabled. " However, EXTEND TERMINAL commands are always supported, regardless of this setting (except OPEN/CLOSE). [. . . ] In this player's Operating Instructions, progressive scan resolutions are followed by a "p" designator (e. However, the device receiving the signal must separate the luminance (Y) and color (C) components once again. The image quality is determined by the accuracy with which these two components can be divided. Some commercial DVD software is recorded with images taken simultaneously from multiple camera angles. [. . . ]