User manual PIONEER DVR-1910LS

[. . . ] CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION: The use of optical instruments with this product will increase eye hazard. This product complies with the EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/ECC). Operation is subject to the following two (2) conditions: ( 1 ) This device may not cause harmful interference ( 2 ) This device must accept any interference received, including interference that Thank you for buying this Pioneer product. [. . . ] contact a Pioneer authorized service representative for repairing this drive (refer to the enclosed Service & Support Card). About DualDisc Playback ­ DualDisc is a two-sided disc with one side containing DVD video / audio / etc. content and the opposite side containing non-DVD content such as digital audio material. The non-DVD audio side is not compliant with the CD Audio Specification; therefore, may not play. The DVD side of DualDisc media plays in this unit. For more details about the DualDisc specification, please refer to the disc manufacturer or your retailer. Note: Some discs may not be playable due to different recording formats or the physical condition of the disc at the time of recording or playback. Write Speed (*CAV, **ZCLV, *** This specification describes the maximum speed in one zone. 25" Half-Height built-in type Stereo Audio Output Horizontal / Vertical orientation Low vibration mechanism LightScribe for identifying/marking discs (with applicable LightScribe software and media) Disc Format (Read/Write) DVD single layer/dual layer / 120mm / 80mm disc DVD-R (when writing, use only 650nm ­ for General use ­ media) DVD-R (4x, 8x, 16x, 18x, 20x write speed) Dual Layer DVD-R and Double Layer DVD+R DVD-RW (1x, 2x, 4x, 6x write speed) DVD+R (2. Note: A specific application program is necessary to write the formats listed above. supported media required for specific DVD and CD writing speeds. When writing to DVD at 12x and 16x and above, use Pioneer-tested media. Com To use LightScribe, a LightScribe drawing software program and applicable media are necessary. When creating a LightScribe disc label image, burning a second drawing on top of the first drawing affects the final label quality. 1) Disc Tray Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with the label facing up. Press the Eject button again or gently push the tray to close and load. Do not attempt to pull out the disc tray forcibly ­ use the Forced Ejection Hole (1). 2) BUSY Indicator Operation status is indicated as follows: During reading: Lights During writing: Lights 3) Forced Ejection Hole If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and push to eject the tray. During normal operation, the eject button should be used to unload the tray. Turn the power to the drive OFF then wait approximately one minute until the disc stops spinning before trying to eject the tray using the Forced Ejection Hole. 15") disc cannot be played when the drive is mounted vertically even with an adapter. The region code can only be changed five (5) times, including the initial setting. [. . . ] Connect an audio output cable to the drive if using a sound card. Do NOT use a power supply other than the internal source provided by the PC. [Position] This unit may be installed vertically as well as horizontally. [Disc Size] 12 cm / 8 cm (Drive does not support non-standard shapes such as business cards, diamond, etc. [. . . ]