User manual PIONEER EFX-500

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This product complies with the Low Voltage Directive (73/ 23/EEC), EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). Thank you for purchasing this Pioneer product. Be sure to read these operating instructions before using your unit to prevent any damage that may result from improper operation. [. . . ] CAUTION: Do not make any connections that may create signal loops as this will cause circuit oscillations which could damage the speakers. Example of connections that must not be performed. (Make sure that the EFFECT SELECTOR, CH SELECTOR and EFFECT ON/OFF on the DJM-500 are correctly set). Connecting a DJ Mixer and an Audio Amplifier (on DJ mixer not provided with SEND and RETURN terminals) ¶ Connect using cables with phone plugs (6. ¶ Do not connect two units using both RCA pin plug and phone plug cords (use only type of connection). Connecting a DJ CD Player and a DJ Mixer (this connection applies effects only to the sound of the DJ CD player on channel 2) ¶ Connect the units using a cable with RCA pin plugs For related information on the use of each control, refer to the pages indicated within brackets "(P. The "OVER" indicator lights when the input level is set too high. The isolator is temporarily ON when moved to the front position and returns to the center (OFF) position when released. The counter flashes when a BPM measurement cannot be made. The sound is flat at the center clicked position and is cut (no sound) at the ­ position. The sound is flat at the center clicked position and is cut (no sound) at the ­ position. The sound is flat at the center clicked position and is cut (no sound) at the ­ position. The "OVER" indicator lights when the output level is set too high. Press the button to light it and the effect currently applied to the sound will continue after the jog dial stops rotating. The Digital Jog Break sound is output when this switch is set to ON. The function is OFF when the switch is set to the center position (through). It is ON and locked at the rear position and is ON temporarily at the front position (the switch returns to the center position when released). The speed of Jog dial rotation changes the amount of control applied to each effect. Holding down this button when the Jog dial is rotated stores up to 8 seconds worth of effects created with the dial. The PLAY button # lights when effects have been saved to memory. Sets the balance between the original sound and the created effect. This switch is located on the front panel of the unit. [. . . ] The memory can store up to 8 seconds of effects generated by the Jog dial of the Digital Jog Break function. Turn the Jog dial while holding down the JOG MEMORY button (M). Turning the Jog dial while the M button is held down starts memory storage. Effects are stored continues for 8 seconds or until the M button is released. [. . . ]