User manual PIONEER F-X303ZL

[. . . ] To prevent a fire or shock hazard, do not place any container filed with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain D3-4-2-1-3_A_En or moisture. When using this product follow the instructions written on the underside of the unit, which concern rated voltage, etc. D3-4-2-2-4_En NOTE: THE NO USER-SERVICEABLE PARTS COMPARTMENT WARNING IS LOCATED ON THE APPLIANCE BOTTOM. IMPORTANT NOTICE ­ THE SERIAL NUMBER FOR THIS EQUIPMENT IS LOCATED IN THE BOTTOM. PLEASE WRITE THIS SERIAL NUMBER ON YOUR ENCLOSED WARRANTY CARD AND KEEP IN A SECURE AREA. THIS IS FOR YOUR SECURITY. D1-4-2-6-1_En READ INSTRUCTIONS -- All the safety and operating instructions should be read before the product is operated. [. . . ] BEAT: Attached foot switch controls beat effect function (ON/ OFF). JOG: Attached foot switch controls digital jog break function (ON/OFF). BOTH: Attached foot switch controls both beat effect function and digital jog break function (ON/OFF). 7 Level meter display 8 MIDI START/CH SET button / indicator [MIDI START] If this button is pressed when MIDI mode is set to [TRANSMIT], the MIDI start/stop signal is output. Lights steadily with START, and goes out with STOP. [MIDI channel setting (CH SET)] If this button is held depressed when MIDI mode is set to [TRANSMIT] or [RECEIVE], the MIDI indicator flashes and the MIDI setting mode is enabled. 4 MIDI mode select switch Select MIDI communication between computer and other instruments, etc. TRANSMIT: Acts as MIDI controller RECEIVE: Effector can be controlled by MIDI signals. OFF: Acts as effector (communication OFF) 14 BEFORE USE (CONTROLS AND FUNCTIONS) 9 BYPASS button / indicator When this button is set to ON, the audio input connector signals are fed directly to the output connectors, bypassing the effector circuits. When the audio input/output connectors are connected directly in this way, the indicator flashes. 20 Beat select buttons / indicators (1/8, 1/4, 1/2, 3/4, 1/1, 2/1, 4/1, 8/1) [During BPM mode] When a BPM is measured automatically or input manually, the beat select button [1/1] is selected by default. The effect is synchronized automatically to the BPM, and the corresponding effect time is displayed. If a beat select button is then pressed, the effect is newly synchronized to the corresponding multiple of the BPM (1/ 8, 1/4, 1/2, 3/4, etc. ), thus allowing one-touch change of the BPM synchronization multiple. In turn, the selected beat select button lights, thus showing to what multiple of the actual BPM the effect is synchronized, as well as the multiple of the time parameter. Indicator flashes during jog memory loop play (playback). 27 Beat effect DEPTH dial Allows adjustment of effect feedback and timing parameters in accordance with the amount of rotation (see page 13). 28 Beat effect CHARACTER dial Allows adjustment of parameters other than those set with the beat effect DEPTH dial (see page 13). 37 Jog HOLD button / indicator When this button is pressed so that its indicator lights, the effect produced when rotating the Jog dial is maintained even if you remove your hand from the dial (when the hold function is OFF, the effect returns to normal if your hand is removed from the dial). When power is first turned on, the button defaults to jog hold OFF (indicator is off). 29 Beat effect MIX dial Rotate to adjust the mixing balance of original and effect sounds. When rotated fully to the [ORIGINAL] side, the original (un-effected) sound will be output; as the dial is rotated toward the [EFFECT] side, the effect sound is amplified and the original sound decreases. 38 DIGITAL JOG BREAK effect lever switch (OFF/ON/ON-LOCK) Pull the lever toward you [ON] to output effected sounds. In the middle position effects are [OFF]; push the lever away from you to lock the lever in the [ON/LOCK] position (effects are locked ON). When pulled to the [ON] position, effects are output only while the lever is held; when your finger is released, the lever returns to middle [OFF] position. Digital Jog Break section 30 Digital jog break effect MIX dial Rotate to adjust the mixing balance of original and effect sounds. When rotated fully to the [ORIGINAL] side, the original (un-effected) sound will be output; as the dial is rotated toward the [EFFECT] side, the effect sound is amplified and the original sound decreases. 39 DIGITAL JOG BREAK effect indicator Lights when digital jog break effect is ON. 31 Digital jog break effect CHARACTER dial Allows adjustment of parameters other than those set with the digital jog break DEPTH dial (see page 13). 40 Digital jog break effect selector buttons / indicators (JET, WAH, PHASE SHIFTER, RING, ZIP, HUMANIZER, VOCODER) Press to select a desired digital jog break effect. All the buttons light, and the select effect button flashes. When power is turned ON, JET flashes. 32 Digital jog break DEPTH dial Allows adjustment of effect feedback and timing parameters in accordance with the amount of rotation (see page 13). 41 DIGITAL JOG BREAK METER 33 Jog dial Effect parameters change in response to the rotation of the dial. During operation of the Jog dial, and during jog memory play, this meter lights to display the corresponding movement. 34 Jog memory button (M) If the Jog dial is rotated while holding this button depressed, the parameter change in response to the movement is recorded to memory, to a maximum 8 seconds. Recording to memory is not possible during jog memory play. 35 Jog memory SINGLE play button / indicator If the button is pressed while the button indicator is lighted, the parameter change previously recorded in memory in response to the Jog dial movement is reproduced (played back) one time only. Indicator lights when the jog operation is stored in memory. [. . . ] Accessories Operating instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Digital link cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Power cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]