User manual PIONEER GEX-P7000TVP

[. . . ] ⷠInstall the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. ⷠWhen mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. ⷠDo not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. [. . . ] Do not drill into the gas line, brake line, electrical wiring or other important parts. ⷠIf this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. ⷠIf this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. Before installing, use a pen tip or other thin, pointed instrument to set the OSD Switch on the right side of this product to the appropriate position for the component you are using it with. This unit is for vehicles with a 12-volt battery and negative grounding. To avoid shorts in the electrical system, be sure to disconnect the (­) battery cable before beginning installation. ⷠRefer to the owner's manual for details on connecting the other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. ⷠThoroughly wipe off the surface before affixing the velcro tape. Voice guidance speaker (supplied with the Display) *2 3. IP-BUS input (Blue)*2 If you are using the AVX-7300 display, connect the IP-BUS input (blue) to another IP-BUS input (blue). Head unit with IP-BUS (sold separately) In case of this connection, this jack is not used. SDV-P7) is not used, use the AV-BUS cable (supplied) instead of the AV-BUS cable <CD-AB301E> (sold separately)*1 in the figure. In case of the connection, this jack is not used. SDV-P7) is not used, use the AV-BUS cable (supplied) instead of the AV-BUS cable <CD-AB301E> (sold separately)*1 in the figure. Use this connection when installing both an AV receiver and a DVD player in the console. In case of the connection, this jack is not used. [. . . ] In case of the connection, this jack is not used. Voice guidance speaker (supplied with the Display) 2. IP-BUS input (Blue)*2 If you are using the AVX-7300 display, connect the IP-BUS input (blue) to another IP-BUS input (blue). [. . . ]