User manual PIONEER HDJ-2000-W

[. . . ] € Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. € Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake, and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. [. . . ] Especially, insulate the nused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated. € To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. Connect the connectors of the same colors correctly. € If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. € Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. t T FRANÇAIS ITALIANO NEDERLANDS 2 Fig. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. Parking brake switch Power supply side Connecting method Ground side Note: • The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Clamp the parking brake switch power supply side lead. A VIC-9DVDII> Blue IP-BUS cable (supplied with TV tuner) This product Yellow ENGLISH ESPAÑOL IP-BUS cable A V-BUS cable (supplied with TV tuner) DVD player (sold separately) <e. GEX-P700DAB> IP-BUS cable (supplied with the DAB tuner) ITALIANO Black Blue A V-BUS cable (supplied with TV tuner) IP-BUS cable Multi-CD player (sold separately) Blue A V-BUS cable (supplied with TV tuner) Black Black NEDERLANDS When a DVD player (e. SDV-P7) is not used, use the AV-BUS cable (supplied with TV tuner) instead of the AV-BUS cable <CD-AB301E> (sold separately)*1 in the figure. Perform [VIDEO SETTING] correctly while referring to the Operation Manual. 4 6 Connecting the Units Connecting the system (B) This Product Remote sensor (supplied with Multi-DVD player) Yellow (VIDEO INPUT or BACK UP CAMERA) Black Blue Multi-DVD player (sold separately) < e. XDV-P9 > AV-BUS cable (supplied with the TV tuner) Blue Black IP-BUS cable (supplied with the TV tuner) IP-BUS cable (supplied with Multi-DVD player) Black Blue Not used. [. . . ] 11) As a rule, secure with side brackets (large). Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. 11 NEDERLANDS 10 Installation 7 When the installation space is not very deep When installing in a shallow space, secure with side brackets (small). [. . . ]