User manual PIONEER HDJ-500-G

[. . . ] Use in other areas may result in poor reception. The RDS (radio data system) function only works in areas that broadcast RDS signals for FM stations. CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007. Do not attempt to install or service this product by yourself. [. . . ] The MW/LW volume level can also be adjusted with this function. USB, iPod and APP are all set to the same setting automatically. Once selected, the following system menu functions can be adjusted. To select the segment of the clock display you wish to set. 12H (12-hour clock)—24H (24-hour clock) AUTO PI (auto PI seek) The unit can automatically search for a different station with the same programming, even during preset recall. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. You can also change the dimmer setting by pressing and holding /DIMMER. MUTE MODE (mute mode) System menu Important PW SAVE (power saving) is canceled if the vehicle battery is disconnected and will need to be turned back on once the battery is reconnected. When PW SAVE (power saving) is off, depending on connection methods, the unit may continue to draw power from the battery if your vehicle’s ignition doesn’t have an ACC (accessory) position. 8 En <QRD3247-A>8 Black plate (9, 1) Section Using this unit Using this unit 02 Sound from this system is automatically muted or attenuated when a signal from equipment with a mute function is received. 10dB ATT – Attenuation PW SAVE (power saving) Switching this function on enables you to reduce the consumption of battery power. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Cover any disconnected cable connectors with insulating tape. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. [. . . ] About the file/format compatibility, refer to the iPod manuals. Audiobook, Podcast: Compatible iPod compatibility This unit supports only the following iPod models. IPhone Depending on the generation or version of the iPod, some functions may not be available. Operations may vary depending on the software version of iPod. [. . . ]