User manual PIONEER KEH-P7200RDS

[. . . ] Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. Speakers connected to this unit must be highpower types with minimum rating of 45 W and impedance of 4 to 8 ohms. [. . . ] To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated. If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. (Install as firmly as possible using the top and bottom tabs. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. Avoid installing this unit in such a location where the operation of safety devices such as airbags is prevented by this unit. Otherwise, there is a danger of a fatal accident. Avoid installing this unit in such a location where the operation of the steering wheel and the gearshift lever may be prevented. Otherwise, it may result in a traffic accident. Do not install this unit in such a place as may obstruct the driver's view. Since interior layout differs depending on the type of vehicle, the ideal installation location for the unit also differs. When installing the unit, select a location that assures optimum transmission of signals from the unit to the car stereo. Installation of this unit should be entrusted to a dealer from whom you purchased this unit. [. . . ] Do not install this unit near the doors where rainwater is likely to be spilled on the unit. Incursion of water into the unit may cause smoke or fire. Fix this unit securely to the steering wheel with the belt attached to the unit. If this unit is loose, it disturbs driving stability, which may result in a traffic accident. [. . . ]