User manual PIONEER KEH-P9200RDS

[. . . ] Support Après avoir introduit le support dans le tableau de bord, sélectíonnez les languettes appropriées en fonction de l'épaisseur du matériau du tableau de bord et courbez-les. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. This unit is for vehicles with a 12-volt battery and negative grounding. [. . . ] To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. If you do, the protection circuit may fail to work when it should. Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. [. . . ] If not, keep the Audio Mute lead free of any connections. Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied manuals of both products and connect cords that have the same function. In this case, be sure to connect 2* to 5* and 4* to 3*. [. . . ]