User manual PIONEER KRL-32V

[. . . ] Consult your dealer if you encounter any difficulties with this installation. Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. Speaker bracket (for TOP-Right) Speaker mounting screw (M5 × 10 mm) Speaker mounting screw (M5 × 10 mm) Speaker bracket (for TOP-Left) There are top and bottom speaker brackets for both the left and the right speaker. Attach the appropriate brackets to the top and the bottom on the back of the speakers using the supplied screws. [. . . ] Attach the appropriate brackets to the top and the bottom on the back of the speakers using the supplied screws. Remove the paper liner on the back of the padding strip and attach the padding strip 1 mm below the top side of the speaker. If the padding strip is too long, cut it. Place the speaker so its terminals (bottom) are facing you. Screw an supplied screw into the speaker mounting hole (lower of the two) at the top, rear of the flat screen TV. Leave it loose, with about 5 mm left to tighten. Adjust the position of the speaker and then tighten the upper and lower screws firmly. Tighten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the flat screen TV. Leave a space of about 5 mm Hang the speaker bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker bracket (top) over the screw, lower the speaker onto it. NOTE: Avoid pinching or creating pressure points when routing or bundling cables. to remove the clamp band , pull and hold the latch to release. To remove the cable clamp, push and hold the levers then pull it out from the hole. Latch Lever For details, refer to the operating instructions supplied with the wall mount unit. Caution Do not move the flat screen TV by holding these speakers or speaker brackets. Lever NOTE: The longer a clamp is in place, the better chance of deterioration. An older clamp is more easily damaged while being removed and may not be reusable. Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. [. . . ] When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. When a chemical cloth is used, read the cautions for the chemical cloth carefully. 5 kg Accessory parts (for two speakers) . [. . . ]