User manual PIONEER KRP-500M

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. [. . . ] Option Off Mode 1 Description no power management (default) panel enters Standby when no signal is received from the PC for eight minutes, using the PC has no effect on the panel panel enters Standby when no signal is received from the PC for eight seconds, using the PC has no effect on the panel When the panel enters Standby with Mode 1 selected (no signals received), receiving signals again does not cause the flat panel display to turn On. When the panel enters the Power Management status with Mode 2 selected (no signals received), receiving signals again causes the flat panel display to turn On. These power management options are unavailable when a PC is connected to the panel through the HDMI port/ terminal. Although earlier sections have mentioned other equipment for playing back video, this section provides control and operation information for specific types of equipment. To operate other equipment or devices through your flat panel display, program the panel's remote control with the equipment's manufacturing code. a manufacturing code is a series of numbers that identify the type of device and the brand. These codes are available in the section entitled "Manufacturer Codes to Program into the Remote Control" in Appendix 9. 1 ) Press SELECT to choose the other device. The selected mode indicator flashes when the remote control is ready to be programmed. 3 ) Use the number buttons to learn a manufacturing code. When you press a button that cannot be learned, the indicator continues to blink. to exit the Learn mode before it finishes , press EDIT/LEARN. 4 ) Press EDIT/LEARN again to exit the Lean mode after the code is confirmed. No operation is performed for more than one minute after having pressed EDIT/LEARN and 2 (the mode indicator is flashing) · You press SELECT Code transmission finishes in approximately two seconds. Do not interrupt the process until the transmission is complete. When using any of the receiver buttons (a, INPUT, or VOL+/­), the learned manufacturer code remains the same. To delete a learned code, overwrite it with a new code on the same button or follow the directions below. The selected mode indicator flashes when the remote control is ready to be programmed. The remote control starts deleting all learned codes for selected modes. 2 Assign a Manufacturing Code to the Remote Control To assign a preset Manufacturing code to the panel's remote control, follow the directions below (Manufacturing codes are listed in section "9. The selected mode indicator flashes when the remote control is ready to be programmed. 3 ) Use the number buttons to enter a manufacturer code. [. . . ] This plug only fits a grounding-type power outlet. If you are unable to insert the plug into an outlet, contact a licensed electrician to replace the outlet with a properly grounded one. Do not defeat the safety purpose of the grounding plug. WARNING: To prevent a fire hazard, do not place any naked flame sources (such as a lighted When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation. [. . . ]