User manual PIONEER MVH-8350BT

[. . . ] Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] High Pass Filter (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. When selecting FM as the source, you cannot switch to SLA. Settings are based on the FM volume level, which remains unchanged. The AM volume level can also be adjusted with this function. Note You cannot select Custom1 and Custom2 when using the auto-equalizer. After selecting, perform the following procedures to set the entertainment function. BGP1 (background picture 1)--BGP2 (background picture 2)--BGP3 (background picture 3) --BGV (background visual)--Photo (photo)-- SPEANA (spectrum analyzer)--Off (display off) 3 Press M. The language can be changed for the following: !If the embedded language and the selected language setting are not the same, text information may not display properly. Some characters may not be displayed properly. To complete this operation, switch the ignition key off and on after you set this setting. Detach Warning (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. AUX Input (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. If you select USB, SD as the source, you cannot select Slide Show. 1 Press and hold SRC/OFF until the unit turns off. After selecting, perform the following procedures to set the initial setting. FM step (FM tuning step) The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. Tune in the stations with manual tuning or use seek tuning again. The tuning step remains at 50 kHz during manual tuning. AM step (AM tuning step) The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. [. . . ] However, it may decrease if used in high temperatures. If the LED backlight reaches the end of its product lifetime, the screen will become dark and the image will no longer be projected. in such cases , please consult your dealer or the nearest authorized PIONEER Service Station. Satellite, cable and/or any other media), broadcasting/streaming via internet, intranets and/ or other networks or in other electronic content distribution systems, such as pay-audio or audio-on-demand applications. [. . . ]