User manual PIONEER MVH-S030BT

[. . . ] Declaration of Conformity with regard to the Radio Equipment Directive 2014/53/EU Manufacturer: Pioneer Corporation 28-8, Honkomagome 2-chome, Bunkyo-ku, Tokyo 113-0021, Japan EU Representative’s & Importer: Pioneer Europe NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium http://www. Eu/ compliance This guide is intended to guide you through the basic functions of this unit. For details, please refer to the Owner’s manual stored on the website. Eu Connections WARNING Important • When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. [. . . ] € When using a subwoofer of 2 Ω, be sure to connect the subwoofer to the violet and violet/ black leads of this unit. Do not connect anything to the green and green/black leads. ˆ it may cause injury to a passenger as a result of a sudden stop. € Install this unit away from hot places such as near the heater outlet. € Optimum performance is obtained when the unit is installed at an angle of less than 60°. € When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. 2 Install the microphone clip on the sun visor. Lowering the sun visor reduces the voice recognition rate. 2 Screw in one screw on each side to hold the unit in place. Trim ring Notched tab • Releasing the front panel allows easier access to the trim ring. € When reattaching the trim ring, point the side with the notched tab down. Leave ample space 5 cm Tapping screw (5 mm × 9 mm, not supplied with product) Mounting bracket Dashboard or console 2 3 Pull the unit out of the dashboard. Insert the supplied extraction keys into both sides of the unit until they click into place. Microphone clip This unit To power cord input Depending on the kind of vehicle, the function of and may be different. In this case, be sure to connect to and to . Yellow Back-up (or accessory) Yellow Connect to the constant 12 V supply terminal. red Accessory (or back-up) Red Connect to terminal controlled by the ignition switch (12 V DC). Connect leads of the same colour to each other. Black (chassis ground) Blue/white The pin position of the ISO connector will differ depending on the type of vehicle. connect and when Pin 5 is an antenna control type. In another type of vehicle, never connect and . Blue/white Connect to the system control terminal of the power amp (max. [. . . ] The indicator moves to the minute setting automatically. Dial to adjust the minute, then press to confirm. Select the FM tuning step from 100 kHz or 50 kHz. To store stations manually 1 Bluetooth connection Up to two Bluetooth telephones can be connected simultaneously. [. . . ]