User manual PIONEER ND-G500

[. . . ] Do not route wires where they will get hot, for example where the heater will blow over them. If the insulation heats up, it may become damaged, resulting in a short-circuit through the vehicle body. ⷠMake sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, handbrake or seat sliding mechanism. [. . . ] ⷠTo prevent malfunction of the amplifier and speakers, the protective circuit will cut the power supply to the amplifier (sound will stop) when an abnormal condition occurs. In such a case, switch the power to the system OFF and check the connection of the power supply and speakers. To prevent an electric shock or short-circuit during connection and installation, be sure to disconnect the negative (­) terminal of the battery beforehand. ⷠDO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result. This unit is for vehicles with a 12-volt battery and negative grounding. If the car stereo is kept on for a long time while the engine is at rest or idling, the battery may go dead. Turn the car stereo off when the engine is at rest or idling. Cradle (Supplied with AVIC-F500BT) Supplied with AVIC-F500BT AMP control male Black Blue/white female Black Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right To Car stereo Black (ground) Cap Do not remove cap if this terminal is not in use. Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right Do not install in: --Places where it could injure the driver or passengers if the vehicle stops suddenly. --Places where it may interfere with the driver, such as on the floor in front of the driver's seat. ⷠMake sure that wires are not caught in the sliding mechanism of the seats, resulting in a shortcircuit. ⷠDO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result. ⷠTo ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the amplifier, or they may become loose causing the amplifier to shut down. [. . . ] ⷠThe best location for installation differs with the car model and installation location. Make temporary connections first and check that the amplifier and the system operate properly. ⷠAfter installing the amplifier, confirm that the spare tire, jack and tools can be easily removed. [. . . ]