User manual PIONEER PDD6-J

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION This product is a class 1 laser product, but this product contains a laser diode higher than Class 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. refer all servicing to qualified personnel. [. . . ] 1 · Note that if you use this feature, make sure that you also have at least one set of analog audio jacks connected to another component for grounding purposes. 1 Decide which component you want to use the remote sensor of. When you want to control any component in the chain, this is the remote sensor at which you'll point the corresponding remote control. For an optical connection, use an optical cable (not supplied) to connect the OPTICAL DIGITAL OUT jack to an optical input on your amplifier. note 1 If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won't be able to control this unit using the remote sensor. Use a cable with a mono mini-plug on each end for the connection. 3 Continue the chain in the same way for as many components as you have. Make sure to complete all connections before connecting to an AC outlet. ⷠConnect the AC power cord to the AC IN inlet on the rear panel of the player, then plug into a power outlet. Keep in mind the following when using the remote control: Make sure that there are no obstacles between the remote and the remote sensor on the unit. ⷠThe remote has a range of about 7 m at an angle of about 30º from the remote sensor. ⷠRemote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. ⷠRemote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit. ⷠReplace the batteries when you notice a fall off in the operating range of the remote. 1 TRACK ­ Lights when the track number is indicated. 2 / ­ Light during playback / when paused. After making sure that everything is connected properly and that the player is plugged in, push the POWER button into the ON position to switch the player on. Load a disc with the label side facing up, using the disc tray guide to align the disc. Once properly seated, press to close the disc tray. The table below shows the basic controls for playing discs. The basic playback controls for playing CDs, SACDs, and MP3/WMA discs are covered here. [. . . ] Problem The disc won't play or is automatically ejected after loading. remedy · Make sure the disc is free from dirt and dust and is not damaged (page 15). Make sure the disc is loaded with the label side face-up and aligned properly in the disc tray guide. Avoid using the player near an air-conditioning unit. [. . . ]