User manual PIONEER PDA-5004

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To ensure proper heat radiation, distance the unit slightly from other equipment, walls, etc. Avoid the following installations which will block vents and cause heat to build up inside, resulting in fire hazards. ⷠDo not attempt to fit the unit inside narrow spaces where ventilation is poor · If planning special installation such as fitting close to the wall, placing it horizontally, etc. [. . . ] Each time the 2/3 buttons are pressed, the language alternates between those available, in the following order: With the desired language displayed, press the SET button. The selected language will be set in memory, and the screen will return to that shown in step 4. When settings are completed, press the MENU button to return to the normal screen image. When the onscreen display language is set to any of INPUT 1 to INPUT 5, the same display language will be set, regardless of the type of input. Follow the procedure described below and make settings as they apply to the type of components connected. Once settings are complete, turn on or reboot (in the cases of computer) your connected component. If settings have been changed while the connected component is turned on, signals may not be output, or signals may not be output in the correct format. These settings are required only when providing input signals with the following refresh rates: 1 31. Adjustment for other signal frequency formats is performed automatically, so no manual setting is required (the [SIGNAL FORMAT] message does not appear). When G ON SYNC or Composite SYNC signals are input, selecting [PC AUTO] will cause the screen resolution to be set to [XGA] only. 㷠When using G ON SYNC or Composite SYNC with WXGA inputs, set [SIGNAL FORMAT] manually to [WXGA]. Use the 5/ buttons to select [SIGNAL FORMAT], then press the SET button. The setting is stored in memory and the screen returns to that shown in step 4. When a component other than a computer is connected, use the 5/ buttons to select [COLOR DECODING] (INPUT1, INPUT2 or INPUT5). The table below shows what settings are appropriate and available for the type of connections made. set [SIGNAL FORMAT] and [COLOR DECODING] as follows. , with RGB output DVI video output of an AV component with DVI output port (PDP505CMX/PDP-50MXE10/ PDP-50MXE11 only) RGB video output of a PC SIGNAL FORMAT 525p 750p 525p COLOR DECODING The [COLOR DECODING] setting is not supported when inputting a computer signal, or when the [SIGNAL FORMAT] function has been used to select a signal other than [525p] or [750p]. Depending on the signal, analog RGB signals may result in the screen image appearing with a whitish or greenish cast. Make this [CLAMP POSITION] setting for each applicable input (PDA-5003: INPUT1 or INPUT5, PDA-5004: INPUT1). 㷠When using this setup, be sure to carefully check the signal output of the component that you are using. For details, please refer to the instruction manual supplied with the component you are connecting. Outlined on the following pages is how to turn the main power on and off, put this display in the operation or standby mode and how to select connected components. [. . . ] Audio output volume remains fixed, even if the VOLUME controls are operated. When finished with the setting, press the MENU button to return to the normal screen image. The volume of the sound output obtained from the AUDIO terminal of PDP-505CMX/PDP-50MXE10/PDP-50MXE11 is [VARIABLE]. Due to improvements, specifications and design are subject to change without notice. [. . . ]