User manual PIONEER PDK-1013

[. . . ] Do not install it outdoors or in a wet place such as at a hot spring or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. The display must always be installed by two or more people to assure it is installed safely. [. . . ] Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. Line up the column supports with the bottom of the plasma display as indicated in the accompanying diagram. On this stand, you can adjust the angle of inclination of the Plasma Display within a range of approximately 2° forward or backward according to your preference. Firmly tighten the forward/backward inclination anchor bolts on the left and right sides by rotating them downward using the enclosed C wrench. Be sure to hold the top of the plasma display with your hand until you have fully tightened the bolts. Be sure to adjust the angle only after you have attached the plasma display. Be sure to install it on a flat table or other flat surface. Be sure to hold the top of the plasma display with your hand while adjusting the angle. Loosen the forward/backward inclination anchor bolts using the enclosed C wrench (2 locations on the left and right). While being sure to hold the top of the plasma display with your hand, loosen the forward/backward inclination anchor bolts on the left and right sides by rotating them upwards using the enclosed C wrench. Check once more to make sure that the forward/backward inclination anchor bolts are fully tightened. Set the angle you prefer by slowly moving the plasma display. Note While adjusting the angle, be very careful to keep your hands out of the place indicated by the arrow on the figure. Be sure to observe the following precautions when moving or installing this product with a plasma display into a rack or other enclosure. Make sure that you always secure a space at least as large as that shown in the following diagram in front of and behind the table top stand. When moving the product more than a few meters, first remove the speaker, then remove the plasma display from the stand and move the speaker, plasma display, and stand separately. When detaching the plasma display from the stand, be sure to follow the procedure described in "Detaching the Plasma Display from the Stand" on page 10. Precautions when installing in a rack or other enclosure When installing in a rack or other enclosure, hold the plasma display by the handles located on the rear Caution and bottom of the plasma display. [. . . ] Where you can lay the plasma display flat, then lay a sheet to protect it from scratches or other damage. Holding the plasma display by its handles and from the bottom, lift the display vertically. Place the plasma display slowly onto the sheet laid out in step 2 with its screen facing downwards. Note When reattaching the plasma display to the stand, be certain that the left/right support columns are set at the same angle. [. . . ]