User manual PIONEER PDK-1015

[. . . ] Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. The display must always be installed by two or more people to assure it is installed safely. [. . . ] The weight of a Plasma Display is about 50 kg (110 lbs), they have no depth, and are unstable. Therefore, at least two people must assemble and install them. Fit the stand's support columns to the bottom of the Plasma Display as indicated by the arrows, then slowly insert them vertically. Be extremely careful not to insert the support columns of the stand into any part of the Plasma Display other than the stand insertion slots. Note that doing so might damage the Plasma Display panel or its ports or result in the warping of the stand. Installation bolts (M6 x 20 mm: black) Line up the column supports with the bottom of the Plasma Display as indicated in the accompanying diagram. Be sure to observe the following precautions when moving or installing this product with a Plasma Display into a TV table or other enclosure. , please be sure that the Plasma Display is held by two people. Except side speaker model Hold the Plasma Display by the handle at the bottom, with your other hand hold the top. When moving the product more than a few meters, first remove the speaker, then remove the Plasma Display from the stand and move the speaker, Plasma Display, and stand separately. When detaching the Plasma Display from the stand, be sure to follow the procedure described in "Detaching the Plasma Display from the Stand" on page 7. Precautions when installing in a TV table or other enclosure When installing in a TV table or other enclosure, hold the Plasma Display by the handle at the bottom, with your other hand hold the top. If you hold the speakers, Caution they may be damaged or twisted. Hold the Plasma Display by the handle at the bottom, with your other hand hold the top. Make sure that you always secure a space at least as large as that shown in the following diagram in front of and behind the table top stand. After installing the stand, be sure to take special care to ensure that the equipment will not fall over. Because of the Plasma Display's weight, if it could fall down, this can result in injury. For safety, be sure to take special care to ensure that the Plasma Display will not fall over. Stabilize the equipment as shown in the diagram using screws that are available on the market. Note A TV table with adequate strength, width and depth should always be used to support the Plasma Display. [. . . ] If a cable clamp is closed too tight, press the button shown on the left and push the extremity of the cable clamp to loosen it. Bundle the cables and place them on each cable clamp. To remove the Plasma Display from the stand, be sure to always follow the procedure described below to prevent accidents. Holding the Plasma Display by its handles at the bottom, with your other hand hold the top, lift the display vertically. [. . . ]