User manual PIONEER PDK-4004

[. . . ] Before installation, turn off the power for the display and peripheral devices then remove the power cord plug from the power outlet. Prevent accidents caused by the product falling over by taking reliable measures to prevent it from falling over (see Page 12). ¶ Consult your dealer if you encounter any difficulties with this installation. ¶ Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. [. . . ] Record the model number and serial number of this equipment below. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Check to make sure that you have all the standard accessories before assembly and installation. This part prevents reflection of the cables connected to the back of the Plasma Display on the base cover. Note Attach it after anchoring the base cover on a flat stable place. While firmly holding the ends of the lightblocking shield, apply it with the doublesided adhesive tape. Anchor it in place while pressing it down from above. Note Be careful that the light-blocking shield does not catch on the pipe insertion holes. anchor it in place so that there are no gaps (See diagram at right). Stop screwing down the bolt when the threads are no longer visible. Note When laying down the Plasma Display, be careful so as to not scratch or damage it. Note Attach the Plasma Display so the light-blocking shield touches the bottom of its back surface. After installing the stand, be sure to take special care to ensure that the equipment will not fall over. Stabilize the equipment as shown in the diagram using screws that are available on the market. Using a wall for stabilization Note To stabilize the equipment on a table, use screws that have a nominal diameter of 6 mm (1/4 inch) and that are at least 20 mm (13/16 inch) long. Using strong cords to firmly stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. Position of screws When stabilizing the stand to a table, use nominal diameter 6 mm (1/4 inch) with a length above 20 mm (13/16 inch). [. . . ] Perform this work in the same way on the left and right sides. Position of screws When stabilizing the stand to a table, use nominal diameter 6 mm (1/4 inch) with a length above 20 mm (13/16 inch). A table or an area of the floor with adequate strength should always be used to support the Plasma Display. When installing the Plasma Display, please take the necessary safety measures to prevent it from falling or overturning in case of emergencies, such as earthquakes, or of accidents. [. . . ]