User manual PIONEER PDK-4006

[. . . ] Before installation, turn off the power for the display and peripheral devices then remove the power cord plug from the power outlet. This product rotates 10° to the left and right and inclines approximately 2° forward and backward. Do not place objects within the range of rotation of this product and the Plasma Display. Install this product so that during routine use or when it is rotated, it does not protrude from the TV table or other location it has been installed. [. . . ] [Support column used: support column S (short columns)] Support column used: support column S (short columns) Note Be sure to carefully store the unused support columns, the hexagonal wrench, the C wrench, and the Operating Instructions together. The weight of a 50 inch Plasma Display(without speaker) is about 34. 2 lbs), that of a 42 inch model is about 29. 9 lbs), they have no Caution depth, and are unstable. Therefore, at least two people must assemble and install them. note Be sure to install it on a flat stable location. Insert the screws in the holes vertically and do not tighten them with more force than necessary. Make sure that you install the support columns reliably with reference to the procedure in "Assembling the Stand". Fit the stand's support columns to the bottom of the Plasma Display as indicated by the arrows, then slowly insert them vertically. Be extremely careful not to insert the support columns of the stand into any part of the Plasma Display other than the stand insertion slots. Note that doing so might damage the Plasma Display panel or its ports or result in the warping of the stand. If the stand protrudes from the TV table, it could cause unforeseen accidents such as the equipment breaking or falling over. When rotating, take care not to allow the display to bump into walls or surrounding objects. Precautions when installing in a TV table or other enclosure When the plasma display you have purchased is PDP-507XD/507XA(except under speaker models)/ PDP-427XD/427XA. Hold the Plasma Display by its handles and from the bottom. Note Be very careful not to apply force to the bases of the cables. After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over. Because of the plasma display's weight, if it could fall down, this can result in injury. For safety, be sure to take special care to ensure that the Plasma Display will not fall over. Stabilize the equipment as shown in the diagram using screws that are available on the market. Note A TV table with adequate strength, width and depth should always be used to support the Plasma Display. Failure to do so could result in falling over. [. . . ] First clear a space on a flat floor etc. Where you can lay the Plasma Display flat, then lay a sheet to protect it from scratches or other damage. Holding the Plasma Display by its handles and from the bottom, lift the display vertically. Place the Plasma Display slowly onto the sheet laid out in step 2 with its screen facing downwards. [. . . ]