User manual PIONEER PDK-5011

[. . . ] Make sure to request installation and mounting from a professional construction company or your sales agent. ã· Pioneer shall not be liable in any way for any accidents or damage resulting from improper installation or mounting, incorrect usage, remodeling, natural disasters or the like. [. . . ] The installation site should (a) be strong enough to support the weight of the plasma display, (b) not allow people to easily hang from or bump into the setup, (c) not be outdoors or in proximity to hot springs or the ocean, and (d) not be subjected to vibration or shock. (e) In addition, a professional construction company should be consulted in the event that the walls are not structurally sound enough to permit installation. (f) Make sure to thoroughly read the Operating Instructions for the plasma display and heed all other cautions pertaining to the installation site. Failure to do so could cause an unexpected accident, such as the display breaking or falling down after it has been installed. (b) For safety reasons, have two or more people perform the work. (c) Prior to starting the work, make sure to turn OFF the plasma display's main power switch and to unplug the power plug from its outlet. Remove the special screws (2 locations) from the bottom of the hung on wall unit. Fix the plasma display to the PDP side hardware with bolt M8 (6 locations). Be sure to use the holes marked with the red triangle "%". Install the wall side hardware (4 locations) symmetrically on the left and right side (one at each location from the center of the ). [. . . ] â· When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if you do, you will apply excessive force, deforming the screw. When it is in this state, do not turn the adjustment screw any further in the closing direction. [. . . ]