User manual PIONEER PDK-FS01E

[. . . ] In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. However the method of connecting and operating the unit is the same. ¶ A design that creates an atmosphere in which the display seems to float in space ¶ Easy to move thanks to the attached casters ¶ Its gooseneck lets you easily rotate the direction of the screen (left or right 30°) This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Do not lean on the plasma display and do not get on the shelf. [. . . ] Because of the characteristics of the glass, it breaks easily if anything strikes its edge. Do not let anything strike the edge of the glass. And be extremely careful to prevent any small children from striking the edge of the glass to protect them from injury. Be extremely careful to keep your hands out of the oscillating part. If you do place your hand in this part, you will injure it. Please check to make sure you have all the parts before beginning the installation. 1 Precaution Because there is a danger of the glass breaking accidentally, we recommend that it be left in its case until it is time to install it. ¶ The height can be adjusted in three stages: high, medium, and low. ¶ The height can be adjusted in three stages: high, medium, and low. 1 Hold the glass stays slightly downward as you insert them into the holes. 2 Push the end of each glass stay downwards and fix it in place by inserting the pin in the notch. ¶ Be sure to spread a sheet or similar protective material to prevent scratches or damage to the display. ¶ Be sure to do this attachment with the plasma display on a table or other flat surface. ¶ Be sure to use the middle and lower level screw attachment positions on the plasma display. Do not perform the attachment by combining the upper and middle levels. The side with the rubber foot is the top side. House the cables inside the column as shown below. ¶ Be extremely careful that the cable is not stretched and that it is not partly jammed in the floor stand when the plasma display is moved to the left or right (max. ¶ Be sure to have two or more people perform the attachment. ¶ Be extremely careful not to jam your figures while doing this task. [. . . ] ¶ Do not move the floor stand by holding the plasma display, speakers, shelf glass, or ornamental base. If you do, you will damage these components. ¶ To move the floor stand over a level difference on the floor, detach the ornamental base and lift the stand by holding the base. It is dangerous to do this because the ornamental base may be displaced or damaged. [. . . ]