User manual PIONEER PDK-FS03

[. . . ] When selecting the location in which the stand is to be placed, be sure to select a location with a surface sufficiently strong to bear the weight of the stand and plasma display. Make sure the installation location is a level, flat, and stable surface and take proper precautions when installing it to make sure its weight is evenly distributed. Depending on the type of surface on which the stand is placed, the legs may leave marks on the surface, and this should be taken into consideration when selecting the place in which the stand is to be placed. Do not install it outdoors, at a hot spring, or near a beach. [. . . ] Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. If the plasma display is fitted with handles, it is usually best to hold the display by its handles when attaching it to the support column. When installing speakers on both sides of the plasma display Insert the support columns into the stand and fix them in place with screws (M5 x 10mm [13/32 inch]). (8 locations) Install each support column so that the side with the symbol ' is forward and the end with the plastic end cap (pointed) is upwards. Line up the column supports with the bottom of the plasma display as indicated in the accompanying diagram. When installing speakers at the bottom of the plasma display Attach the support column stoppers to the notches on the back of the stand and fix them in place with screws (M5 x 10mm [13/ 32 inch]). Be sure to work with at least one other person when attaching the display. Be careful not to allow your fingers get caught between the display and support column. Use the hexagonal bolts to fix the plasma display to the support column (4 locations). It you are attaching speakers, do so at this stage. See the installation instructions provided with your speakers for instructions on how to install them. 1 Remove the shelf cover and then attach the shelf supports L and R to the stand. Put the media receiver installed on a upright use stand (see the plasma display operating instructions for the installation method) on the shelf at the rear and fix the upright use stand in place with the MR stand's front and back metal fittings. Do not install any device other than a media receiver in this position. Shelf support R Push rivet MR stand's front metal fitting Push rivet MR stand's back metal fitting Push in Shelf support L 2 Push the shelf panel in from behind and fix it in place with the push rivet. The shelf panel installation position be selected from two levels: either the front or the back. set it accorrding to the device you have. When changing its position, you can easily remove it by pulling up the knob on the top of the push rivet. [. . . ] Lorsque vous choisissez l'emplacement où sera placé le support de base, veillez à sélectionner un endroit avec une surface de base suffisamment solide pour supporter le poids du support de base et de l'écran d'affichage plasma (Le poids du produit est indiqué sur le Tableau figurant à la page 17. ) · S'assurer que l'emplacement d'installation est bien plane et à niveau et prendre toutes les précautions utiles et indispensables lors de l'installation du support afin de veiller à ce que le poids soit bien uniformément réparti. Selon le type de surface sur lequel sera placé le support de base, les pieds pourront éventuellement laisser des traces sur ladite surface et ceci devra être prendre en considération lorsque l'on sélectionnera l'endroit où sera installé le support de base. Fixer les colonnes de support au support de base. [. . . ]