User manual PIONEER PDK-FS05

[. . . ] When selecting the location in which the stand is to be placed, be sure to select a location with a surface sufficiently strong to bear the weight of the stand and plasma display (Product weight is listed on page 15). Make sure to place it in a level and stable location. Depending on the type of surface on which the stand is placed, the casters may leave marks on the surface, and this should be taken into consideration when selecting the place in which the stand is to be placed. Do not install it outdoors, at a hot spring, or near a beach. [. . . ] Long support legs Slide grooves into place PDP bracket The types of plasma displays which may be used with the stand differ depending on the length of the support legs attached to the PDP bracket, so you should check to see if the display to be attached is compatible before proceeding. Fit the stand's support columns to the bottom of the plasma display as indicated by the arrows, then slowly insert them vertically. Be extremely careful not to insert the support legs of the stand into any part of the plasma display other than the stand insertion slots. Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. If the plasma display is fitted with handles, it is usually best to hold the display by its handles when attaching it to the support legs. Line up the support legs with the bottom of the plasma display as indicated in the accompanying diagram. If speakers are to be installed at the sides or the bottom of the plasma display, they should be attached at this phase. See the installation instructions provided with your speakers for instructions on how to install them. When installing the one body type plasma display Use the following bolts to fix it with the hexagonal wrench. Be sure to work with at least one other person when attaching the display. Be careful not to allow your fingers get caught between the display and support legs. If the PDP bracket has been placed into the upper bracket holes and speakers are to be installed below the plasma display or one body type plasma display, care must be taken to ensure that the display is firmly supported as its position will be higher. Attach left and right glass stays to support column. 1 Insert the glass stays into the holes provided, pushing them all the way into the holes so that they point slightly downwards. 2 Press down on the tips of the glass stays to lower them and fit the indentations into frames. 2 Fix it with the screws (M4 x 10 mm: black) (2 locations: left and right). Side with the rubber guard is the upper side. Glass stays may be inserted into the upper, middle, or lower holes to adjust the height of the glass panel (The middle holes are designed to be used for standard installation). Be sure to use the screws to fix the glass panel into place. Note that failing to do so could cause the glass panel to fall off if you come into contact with Caution it and result in the panel breaking. Place the equipment to be connected to the display onto the glass panel and then connect the equipment to the display. Note that the glass panel and base are designed to be able to withstand loads of up to only 20 kilograms (44. [. . . ] Selon le type de surface sur lequel sera placé le support de base, les roulettes pourront éventuellement laisser des traces sur ladite surface et ceci devra être prendre en considération lorsque l'on sélectionnera l'endroit où sera installé le support de base. Lorsque vous déplacez le support de base, vous devez toujours suivre scrupuleusement les instructions données à la page 22 dans le chapitre intitulé "Déplacement du support et de l'écran". (Le support de base qui figure ci-dessous est un support pour un écran à plasma de 43 pouces) Faites glisser la colonne de support centrale dans les rails du support de base et fixez-la au moyen de vis à six pans (4 emplacements). Utiliser les vis courtes à six pans pour fixer le support PDP à la colonne de support centrale (les boulons doivent être vissés à quatre endroits). [. . . ]