User manual PIONEER PDK-FS06

[. . . ] ¶ Consult your dealer if you encounter any difficulties with this installation. ¶ Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. When selecting the location in which the stand is to be placed, be sure to select a location with a surface sufficiently strong to bear the weight of the stand and plasma display. (Product weight is listed on page 8) · Make sure the installation location is a level, flat, and stable surface and take proper precautions when installing it to make sure its weight is evenly distributed. [. . . ] Fit the stand's support columns into the slots in the center of the bottom of the plasma display then slowly insert them directly into the slots. Be extremely careful not to insert the support columns of the stand into any part of the plasma display other than the stand insertion slots. Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. If the plasma display is fitted with handles, it is usually best to hold the display by its handles when attaching it to the support column. Use the short or the long hexagonal bolts to fix the plasma display to the support column (4 locations). please install starting with the bolts on the top. When installing the PDP-506XDE / PDP-506FDE / PDP506HDG / PDP-5060HD / PDP-436XDE / PDP-436FDE / PDP-436HDG / PDP-4360HD / PRO-1130HD / PRO-930HD Use the following bolts to fix it with the hexagonal wrench. Short hexagonal bolts (M8 x 35 mm [1-3/8 inch]: black) Line up the column supports with the bottom of the plasma display as indicated in the accompanying diagram. It you are attaching speakers, do so at this stage. See the installation instructions provided with your speakers for instructions on how to install them. When installing the one body type plasma display Use the following bolts to fix it with the hexagonal wrench. Be sure to work with at least one other person when attaching the display. Be careful not to allow your fingers get caught between the display and support column. 1 Remove the shelf cover and then attach the shelf supports L and R to the stand. 1 Fit the MR holder over the sides of the media receiver and fix into place using the four screws (M4 x 6 mm [1/4 inch]). The legs of the MR holder are on the side of the holder with the indentations. Be sure to attach the holder in the correct direction. Do not attach the MR holder to anything other than a media receiver. Push in Shelf support R Media receiver 2 Push the shelf panel in from behind and fix it in place with the push rivet. The shelf panel installation position be selected from two levels: either the front or the back. set it accorrding to the device you have. When changing its position, you can easily remove it by pulling up the knob on the top of the push rivet. [. . . ] Selon le type de surface sur lequel sera placé le support de base, les pieds pourront éventuellement laisser des traces sur ladite surface et ceci devra être prendre en considération lorsque l'on sélectionnera l'endroit où sera installé le support de base. Fixer les colonnes de support au support de base. Emplacement des hautsparleurs Emplacement de la colonne du support Modalité d'assemblage Butée d'arrêt de la colonne du support Vis (M5 x 10 mm) Introduire les deux colonnes de support dans le support de base et les mettre en place en les immobilisant avec les vis (M5 x 10 mm). Placez les butées d'arrêt de la colonne du support dans les fentes supérieures prévues à cet effet à l`arrière du support et fixez-les à l'aide des vis (M5 x 10 mm). [. . . ]