User manual PIONEER PDK-LS01

[. . . ] This product is a table top stand exclusively designed for plasma televisions (PDP-LX508D / PDP-LX5080D / PDP-5080XA / PDP-5080XD / PDP508XD /PDP-SX5080D / PDP-4280XA / PDP-4280XD / PDP-428XD / PDP-SX4280D) from Pioneer. Use with other model is capable of resulting in instability causing possible injury. For further information, please contact the store where you purchased your display. Do not install or modify the product other than specified. [. . . ] â· Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. Record the model number and serial number of this equipment below. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Check to make sure that you have all the standard accessories before assembly and installation. Accessories 2 For 50 inch model (under speaker): gray x 2 * This attachment is used only when installing a 50 inch model (under speaker) or a 42 inch model. The attachment is used only with one of three models: it is not used with the other two models. The above specifications and exterior may be modified without prior notice to improve the product. Align the long holes in the tooling and in the column and lay them on their side. Attach the stand by aligning the screw hole on the bottom of the column with the protrusion on the base. Be careful that you do not strike the glass. Tighten the screws on the back surface of the base with a hexagonal wrench (three locations). The weight of a 50 inch model (without speakers) is about 34 kg, that of 42 inch model is about 30 kg, they have no depth, and are unstable. Therefore, at least two people must assemble and install them. In the case of the 50 inch model (side speakers), prepare black attachments. Attach it to the screw hole beside the letter "W (top side)" on the back surface of the plasma television. The size of the attachment that is used varies according to your plasma television, so be careful about its size. The position the plasma television is hung varies according to the type of plasma television you have. Make sure that nothing is placed on top of the glass plate. Case of the 50 inch model (under speaker) or 42 inch model 50 inch model (When installing under speaker) 42 inch model 50 inch model (When installing under speaker) 42 inch model This illustration shows the case of a 50 inch model (side speakers) Fix the stand and plasma display firmly in place with installation screws (M8 x 20 mm). Installation screws (M8 x 20 mm) This illustration shows the case of a 50 inch model (side speakers) , please be sure that the plasma television is held by two or more people. [. . . ] Fix the plasma television using the screws (M5 x 15 mm) and falling prevention hardware as shown in the diagram. Note To stabilize the equipment on a table, use screws that have a nominal diameter of 4 mm and that are at least 20 mm long. 20 mm This illustration shows the case of a 50 inch model (side speaker) Screws (M5 x 15 mm) Using a wall for stabilization Using strong cord to firmly stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. This illustration shows the case of a 50 inch model (side speaker) Indien dit model met een ander model wordt gebruikt kan dit tot instabiliteit leiden hetgeen letsel kan veroorzaken. [. . . ]