User manual PIONEER PDK-TS10

[. . . ] Use with other model is capable of resulting in instability causing possible injury. For further information, please contact the store where you purchased your display. Do not install or modify the product other than specified. [. . . ] Record the model number and serial number of this equipment below. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Check to make sure that you have all the standard accessories before assembly and installation. Turn the base cover over so the underside is facing up. The weight of a 50 inch Plasma Display is about 40 kg (88 lbs), that of a 43 inch model is about 30 kg (66 lbs), they have no depth, and are unstable. Therefore, at least two people must assemble and install them. Note Insert the bolts in the holes vertically and do not tighten them with more force than necessary. Place a sheet or protective cover to protect the display from scratches or damage. Assemble only with the Plasma Display lying flat on a table or similar surface. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. 7 Regarding the stand pipe screw holes when the stand is used as a desktop stand Table: Stand pipe screw holes when the stand is used as a desktop stand Plasma Display model 43 inch display model When installing the optional speakers to the bottom of the Plasma Display (PDP-436FDE only) 50 inch display model Screw holes used with stand orientation With the Plasma Display lying flat, insert and secure the two Installation bolts 2 (M8 x 20 mm: black) in the holes "a" located in center of the Plasma Display housing. At this point, tighten these bolts 2 only until the threads are no longer visible when viewed from the side (you will be unable to attach the display if the bolts are screwed in completely). Stop screwing down the bolt when the threads are no longer visible. As shown in the above figure, hook the stand pipe holes (either pipe A or B) onto the screw heads of the installation bolts 2, then slide the stand upwards to the main Plasma Display until it engages the installation bolts 2 (once put together with the display, the stand will slides no more than 19 mm (3/4 inch)). Pass the installation bolts 3 (M8 x 40 mm: black) through the stand pipes and tighten the installation bolts firmly with the accessory hexagonal wrench (The holes should be used in the proper combinations, A­A' and B­B'). Note When laying down the Plasma Display, be careful so as to not scratch or damage it. If you hold the speakers, they may be damaged or twisted. When installing speakers on both sides of the plasma display: When laying down the Plasma Display: When installing speakers at the bottom of the plasma display: After installing the stand, be sure to take special care to ensure that the equipment will not fall over. [. . . ] The above specifications and exterior may be modified without prior notice to improve the product. When installing speakers on both sides of the Plasma Display When installing speakers at the bottom of the Plasma Display (PDP-436FDE only) Insérez les colonnes de support dans le support de couverture de table. Déplacez le support de manière à ce que les fentes du support destinées à recevoir les vis et les boulons qui raccordent l'écran principal soient parfaitement alignées. [. . . ]