User manual PIONEER PDK-TS15

[. . . ] Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. The display must always be installed by two or more people to assure it is installed safely. [. . . ] Fit the stand's support columns to the bottom of the Plasma Display as indicated by below, then slowly insert them vertically. Be extremely careful not to insert the support columns of the stand into any part of the Plasma Display other than the stand insertion slots. Note that doing so might damage the Plasma Display panel or its ports or result in the warping of the stand. Line up the column supports with the bottom of the Plasma Display as indicated in the accompanying diagram. Be sure to observe the following precautions when moving or installing this product with a Plasma Display into a TV table or other enclosure. , please be sure that the Plasma Display is held by two people. Make sure that you always secure a space at least as large as that shown in the following diagram in front of and behind the table top stand. When moving the product more than a few meters, first remove the speaker, then remove the Plasma Display from the stand and move the speaker, Plasma Display, and stand separately. When detaching the Plasma Display from the stand, be sure to follow the procedure described in "Detaching the Plasma Display from the Stand" on page 13. Precautions when installing in a TV table or other enclosure do not hold the speaker Hold the Plasma Display by the handle at the bottom, with your other hand hold the top. When installing in a TV table or other enclosure, hold the Plasma Display by the handle at the Caution bottom, with your other hand hold the top. If you hold the speakers, they may be damaged or twisted. Close each cable clamp, and then pull its extremity to make the cables immobile. Be very careful not to apply force to the bases of the cables. If a cable clamp is closed too tight, press the button shown on the left and push the extremity of the cable clamp to loosen it. Bundle the cables and place them on each cable clamp. After installing the stand, be sure to take special care to ensure that the equipment will not fall over. Because of the Plasma Display's weight, if it could fall down, this can result in injury. [. . . ] Select the appropriate screws, hooks, chains and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. To remove the Plasma Display from the stand, be sure to always follow the procedure described below to prevent accidents. Holding the Plasma Display by its handles at the bottom, with your other hand hold the top, lift the display vertically. Place the Plasma Display slowly onto the sheet laid out in step 1 with its screen facing downwards. [. . . ]