User manual PIONEER PDK-TS24

[. . . ] Use with other model is capable of resulting in instability causing possible injury. For further information, please contact the store where you purchased your display. [. . . ] Turn the base cover over so the underside is facing up. The weight of a 50 inch Plasma Display is about 34. 2 lbs), that of a 42 inch model is about 29. 0 lbs), they have no depth, and are unstable. Therefore, at least two people must assemble and install them. Note Insert the bolts in the holes vertically and do not tighten them with more force than necessary. Place a sheet or protective cover to protect the display from scratches or damage. Assemble only with the Plasma Display lying flat on a table or similar surface. Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. Regarding the stand pipe screw holes when the stand is used as a desktop stand Table: Stand pipe screw holes when the stand is used as a desktop stand Plasma Display model 42 inch display model 50 inch display model(except under speaker models) 50 inch display model(under speaker models) Screw holes used with stand orientation With the Plasma Display lying flat, insert and secure the two Installation bolts 2 (M8 x 20 mm: black) in the holes "a" located in center of the Plasma Display housing. At this point, tighten these bolts 2 only until the threads are no longer visible when viewed from the side (you will be unable to attach the display if the bolts are screwed in completely). Installation bolt 2 Stop screwing down the bolt when the threads are no longer visible. As shown in the above figure, hook the stand pipe holes (either pipe A or B) onto the screw heads of the installation bolts 2, then slide the stand upwards to the main Plasma Display until it engages the installation bolts 2 (once put together with the display, the stand will slides no more than 19 mm (3/4 inch)). Pass the installation bolts 3 (M8 x 40 mm: black) through the stand pipes and tighten the installation bolts firmly with the accessory hexagonal wrench (The holes should be used in the proper combinations, A­A' and B­B'). [. . . ] Prise en compte des fentes de la colonne de support lorsque le support est utilisé comme support de bureau Tableau : fentes de la colonne de support lorsque le support est utilisé comme support de bureau Comme le montre le schéma ci-dessus, accrochez ensuite les fentes de la colonne de support (colonne A ou B) sur les têtes de vis des vis d'installation 2, puis faites glisser le support vers le haut sur l'écran à plasma principal jusqu'à ce que le support s'enclenche dans les vis d'installation 2 (une fois qu'il est assemblé à l'écran, le support glisse tout au plus de 19 mm). Indien dit model met een ander model wordt gebruikt kan dit tot instabiliteit leiden hetgeen letsel kan veroorzaken. [. . . ]