Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PIONEER PDK-TS30. We hope that this PIONEER PDK-TS30 user guide will be useful to you.
Lastmanuals help download the user guide PIONEER PDK-TS30.
Detailed instructions for use are in the User's Guide.
[. . . ] Do not install it outdoors, at a hot spring, or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. [. . . ] If a sheet is not laid before assembly, the front surface of the base cover may be scratched. Please take care when installing stand pipes (L) and (R) to ensure that they are in the correct positions. This part prevents reflection of the cables connected to the back of the plasma television on the base cover. Note Attach it after anchoring the base cover on a flat stable place. While firmly holding the ends of the lightblocking shield, apply it with the doublesided adhesive tape. Front Base cover Be careful that the light-blocking shield does not catch on the pipe insertion holes. anchor it in place so that there are no gaps (See diagram at below). If there is a gap, the light-blocking shield may peel off. Anchor it in place while pressing it down from above. The weight of a plasma television is about 55. 4 lbs), they have no depth, and are unstable. Caution Therefore, at least two people must assemble and install them. note Be sure to install it on a flat stable location. Insert the screws in the holes vertically and do not tighten them with more force than necessary. place a sheet or other material under the display to prevent scratches or damage to it. After manually turning the screw lightly two or three times, tighten it with a screw-driver. Align the stand supports with the plasma television stand slots, and slowly insert the supports horizontally. Please ensure that the stand supports do not come into contact with anything other than the plasma television stand slots. [. . . ] Note To stabilize the equipment on a table, use screws that have a nominal diameter of 4 mm (5/32 inch) and that are at least 20 mm (13/16 inch) long. Using a wall for stabilization Using strong cords to firmly stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PIONEER PDK-TS30
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PIONEER PDK-TS30 will begin.
