User manual PIONEER PDK-TS36B

[. . . ] Make sure to place it in a level and stable location. Do not install it outdoors or in a wet place such as at a hot spring or near a beach. Do not install the stand where it may be subjected to vibration or shock. There have been cases where unforeseen accidents such as the equipment breaking or falling over occurred after the installation of the display because the stand was not installed as instructed. [. . . ] On this stand, you can adjust the angle of inclination of the Pioneer television within a range of approximately 2° forward or backward according to your preference. Firmly tighten the forward/backward inclination anchor bolts on the left and right sides by rotating them downward using the enclosed C wrench. Be sure to hold the top of the Pioneer television with your hand until you have fully tightened the bolts. Be sure to adjust the angle only after you have attached the Pioneer television. Be sure to install it on a flat table or other flat surface. Be sure to hold the top of the Pioneer television with your hand while adjusting the angle. Loosen the forward/backward inclination anchor bolts using the enclosed C wrench (2 locations on the left and right). While being sure to hold the top of the Pioneer television with your hand, loosen the forward/backward inclination anchor bolts on the left and right sides by rotating them upwards using the enclosed C wrench. Check once more to make sure that the forward/backward inclination anchor bolts are fully tightened. Set the angle you prefer by slowly moving the Pioneer television. While adjusting the angle, be very careful to keep your hands out of the place indicated by the arrow on the figure. Be sure to observe the following precautions when moving or installing this product with a Pioneer television into a TV table or other enclosure. Make sure that you always secure a space at least as large as that shown in the following diagram in front of and behind the table top stand. When moving the product more than a few meters, first remove the speaker, then remove the Pioneer television from the stand and move the speaker, Pioneer television, and stand separately. When detaching the Pioneer television from the stand, be sure to follow the procedure described in "Detaching the Pioneer Television from the Stand" on page 10. When installing in a TV table or other enclosure, hold the Pioneer television by the handles located on the rear of the Pioneer television. If you hold the speakers, they may be damaged or twisted. When the Pioneer television you have purchased is under speaker models. Hold the Pioneer television by its handles and from the top. If the stand protrudes from the TV table, it could cause unforeseen accidents such as the equipment breaking or falling over. When rotating, take care not to allow the display to bump into walls or surrounding objects. Hold the Pioneer television by its handles and from the top. [. . . ] Where you can lay the Pioneer television flat, then lay a sheet to protect it from scratches or other damage. Holding the Pioneer television by its handles and from the bottom, lift the display vertically. Place the Pioneer television slowly onto the sheet laid out in step 2 with its screen facing downwards. When reattaching the Pioneer television to the stand, be certain that the left/right support columns are set at the same angle. [. . . ]