User manual PIONEER PDK-WT02

[. . . ] Do not install it at a place where people can easily hang from it or lean on it. â· Do not install it outdoors, at a hot spring, or near a beach. â· Do not install where vibration or shock may occur. â· There are cases where it cannot be installed because of the structural strength of the wall, so consult with an expert installer. [. . . ] If the hung on wall unit is used for a long time, the environment may cause change over time, reducing its strength. After five years, ask an expert installer to inspect it to make sure that it can be used without any problems. This symbol refers to a hazard or unsafe practice which can result in personal injury or property damage. Before assembly, check to make sure that none of the parts provided are missing. Remove the special screws (2 locations) from the bottom of the hung on wall unit. After using them, please retain them carefully. Screws to be used for wall installation are not included. Cover the display with a sheet or similar protective material to protect it from scratches or other damage. Place them so that the holes in the spacers are aligned with the holes in the plasma display. Install the wall side hardware (4 locations) symmetrically on the left and right side (one at each location from the center of the ). Because the screws and bolts used to do this are different according to the wall strength and wall material, purchase suitable screws and bolts separately. note Check the strength of the wall and beams before installing the display. With the plasma display separated from the PDP side hardware by spacers, fix the plasma display to the hardware with bolt M8 (4 locations). Use the hole marked with a red "%" as the standard. If the angle of incline is increased, the top of the angle adjustment use screw may be visible from a horizontal position on the front. In this case, you can hide the top of the screw by using the hole towards the top not marked with a red "%". 1 First turn the screw in the center of the PDP side Hardware in the direction that opens it to raise the tilted part then attach the hook so that the attachment part is visible. 2 Attach the attachment part firmly, then check to make sure that the plasma display has been horizontally attached in the correct position. Do not hold the speakers during the installation work. If you plan to install speakers and cables, please install them at this stage. [. . . ] When this happens, adjust it at the center of the upper. Turn the screws very carefully to avoid damaging the wall. When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if you do, you will apply excessive force, deforming the screw. When it is in this state, do not turn the adjustment screw any further in the closing direction. [. . . ]