User manual PIONEER PDP-42MVE1

[. . . ] This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. After installation, be sure to deliver this manual to the customer and explain to the customer how to handle the product. [. . . ] Press STANDBY/ON to put the unit in the operation mode. Make this setup for each input (INPUT1 and INPUT2). Depending on the signal, analog RGB signals may result in the screen image appearing with a whitish or greenish cast. Make this CLAMP POSITION setting for each applicable input (INPUT1 and INPUT2). When using this setup, be sure to carefully check the signal output of the component that you are using. For details, please refer to the instruction manual supplied with the component you are connecting. This section explains the basic operation of this unit. Outlined on the following pages is how to turn the main power on and off, put this unit in the operation or standby mode and how to select connected components. Press INPUT on the remote control unit or the main unit to select the input. Before you begin, make sure you have: Made connections between this unit and personal computer as described in the section "Installation and Connections" starting on page 8. If no connections are made to these terminals, on-screen setup is not necessary. When DOT BY DOT or 4:3 screen sizes are selected, the display position is moved slightly each time the power is turned on, in order to prevent image burning. 3 FULL The display is presented with a widescreen aspect ratio of 16:9 and fills the entire screen. During personal computer input (1280 x 1024/60Hz only), even when the PARTIAL setting is selected, the position of the screen can be adjusted by using 5/. The adjustment value will not, however, be stored in memory. However, in order to maintain the 1:1 ratio, a portion of the display will not appear on the screen. 768 lines 1024 lines This display allows any one of nine screen areas (AREA 1 to AREA 9) to be selected and enlarged to x1. When performing point zoom enlargement, the direction buttons (5//2/3) can be used to move the enlarged portion up-down and right-left. Pressing SET repeatedly changes the zoom ratio in the following order: When the zoom ratio is changed, the screen image is enlarged based on the screen center. 5//2/3 can be used to move the enlarged portion up-down and right-left. If no operation is undertaken for three seconds or more, the display screen will disappear. SET or 5//2/3 can be pressed again if desired to change the zoom ratio or display position. [. . . ] The display should be used within ambient temperature conditions below 40°C. 3 The vents are blocked or the internal temperature has risen abnormally due to abnormal heat generation of internal parts etc. 4 If the display is moved suddenly from a chilled location to a warm room, or if the room temperature rises suddenly, condensation may form on internal parts. To protect internal circuitry, the display is provided with a condensation detector that automatically disables power in event of internal condensation; in this case, allow the unit to dry thoroughly before using. [. . . ]