User manual PIONEER PDP-42MXE20

[. . . ] English This unit has been designed for use as a computer display monitor. The optional video card is required if you wish to view other video signals on the monitor. Thank you very much for purchasing this PIONEER product. Before using your Plasma Display, please read the "Safety Precautions" and these "Start up Guide" carefully so you will know how to operate the Plasma Display properly. [. . . ] ã· The installation location selected should be fully capable of supporting the weight of this unit, and be a stable, flat, and even surface. If installed in other locations, the unit may fall or be damage. ã· After installation, take appropriate measures to prevent the installation from falling. The failure to take such measures could allow the unit to fall, causing injuries or damage. ã· When this unit is installed on a wall, the work should be done by a professional technician possessing the requisite technical knowledge and abilities; consult your dealer for more information. Handles should not be removed or reattached by anyone other than the professional installation technician or service personnel. ã· When moving the display, it should always be carried by two persons holding the rear handles in the manner shown. Never attempt to move the Plasma Display by holding only one of the handles. Fix this unit using the supplied washers and hex hole bolts. Main unit Center line a hole a hole a hole Bolt 12 mm to 18 mm Screw provided with speaker unit (sold separately) Main unit Center line a hole a hole a hole Bolt 12 mm to 18 mm Screw provided with speaker unit (sold separately) Main unit Center line a hole a hole a hole Bolt 12 mm to 18 mm Screw provided with speaker unit (sold separately) Connect the power cord after all component connections have been completed. Power cord (PDP-60MXE20/PDP-50MXE20/PDP50MXE20-S) Attach the accessory ferrite core to the end of the power cord as shown in the accompanying illustration. Use the provided cable tie to prevent the ferrite core from slipping on the cable. If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards. Power cord (PDP-42MXE20) Attach the accessory ferrite cores to the both connector ends of the power cord as shown in the accompanying illustration. Use the provided cable tie to prevent the ferrite core from slipping on the cable. If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards. Plug the power cord into a power outlet. ã· For the Plasma Display, use a three-core power cord with a ground terminal. Always be sure to connect the power cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line. Do not use a power supply voltage other than that indicated (AC 100 V to 240 V, 50 Hz/60 Hz) as this may cause fire or electric shock. To power outlet AC power cord Wind the audio cable (not supplied) around the ferrite core once, and then fasten the catch. [. . . ] 3 The internal temperature has risen abnormally due to blocked cooling vents, overheating of internal electronic parts, or other factors. If the power is automatically turned off for a reason other than the above reasons, there could be a malfunction. In this case, unplug the power cord from the power outlet and request repair from your nearest sales outlet. â· The Plasma Display panel of this unit is very bright and viewing it a close distance will cause eye strain. [. . . ]