User manual PIONEER PDP-433MXE

[. . . ] English This unit has been designed for use as a computer display monitor. The optional video card is required if you wish to view other video signals on the monitor. Thank you very much for purchasing this PIONEER product. Before using your Plasma Display, please read the "Safety Precautions" and these "Operating Instructions" carefully so you will know how to operate the Plasma Display properly. [. . . ] When using this setup, be sure to carefully check the signal output of the component that you are using. For details, please refer to the instruction manual supplied with the component you are connecting. This section explains the basic operation of this unit. Outlined on the following pages is how to turn the main power on and off, put this unit in the operation or standby mode and how to select connected components. Press INPUT on the remote control unit or the main unit to select the input. Before you begin, make sure you have: Made connections between this unit and personal computer as described in the section "Installation and Connections" starting on page 10. If no connections are made to these terminals, on-screen setup is not necessary. When the menu screen is displayed, changing the signal input will cause the menu screen to turn off. If the input computer signal is not supported by the display, the following message will be displayed: Use VOLUME +/­ on the remote control unit to adjust the volume. If no audio connections are made to this unit, this step is not necessary. When viewing is finished, press STANDBY/ON to put the unit in standby mode. the STANDBY/ON indicator will blink and then remain lit (red) indicating that the standby mode is engaged. Operation is not possible while the STANDBY/ON indicator is blinking (red). Switch MAIN POWER on the main unit to the off position to turn the main power off. The STANDBY/ON indicator may continue to light for a short while even after the main power is turned off. This is a result of residual electric load impressed on the circuitry, and the light will turn off presently. Switch MAIN POWER on the main unit to the on position to turn the main power on. Please do not leave the same picture displayed on the screen for a long time. Doing so may cause a phenomenon known as "screen burn" which leaves a ghost, or residual, image of the picture on the screen. The currently selected input, screen size and refresh rates will be displayed for about 3 seconds. The displayed refresh rates may be slightly different from actual values. Muting is automatically canceled about 8 minutes after the button is pressed, and the volume level is adjusted to the minimum level. [. . . ] The plasma display panel of this unit is very bright and viewing it a close distance will cause eye strain. We recommend that you view the screen from a suitable distance (3 to 6m). This may occur in the following two cases. After-image lagging due to remaining electrical load When image patterns with very high peak luminance are displayed for more than 1 minute, after-image lagging may occur due to the remaining electric load. [. . . ]