User manual PIONEER PDP-5000EX

[. . . ] Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. [. . . ] The screws, hooks, chains and other fittings that you use to secure the Plasma Display to prevent it from overturning will vary according to the composition and thickness of the surface to which it will be attached. Select the appropriate screws, hooks, chains, and other fittings after first inspecting the surface carefully to determine its thickness and composition and after consulting a professional installer if necessary. To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable. To power outlet AC power cord When not using this unit for extended periods, disconnect the power cord from its outlet. This unit is equipped with speaker output terminals. Consult the accompanying illustration when connecting your own speakers. Then, close tab firmly to secure the wire in place. When connecting speakers, be sure to connect the speaker's positive (+) and negative (­) terminals to the same terminals on this unit. Proper sound will not be produced if the (+) and (­) polarities are not connected correctly. This unit supports the use of speakers with 8 to 16 impedance. Speed clamps and bead bands are included with this unit for bunching cables together. Once components are connected, follow the following steps to route cables. Organize cables together using the provided speed clamps. Insert into an appropriate hole on the rear of the unit, then snap into the back of to fix the clamp. Speed clamps are designed to be difficult to undo once in place. Bunch separated cables together and secure them with the provided bead bands. Do not allow excessive stress to be placed on the ends of cables. To attach the speed clamps to the main unit Connect the speed clamps using the 6 holes marked with "o" below, depending on the situation. Using pliers, twist the clamp 90° and pull it outward. In some cases the clamp may have deteriorated over time and may get damaged when removed. It can also reduce the life or performance of batteries. [. . . ] Are batteries inserted with polarity (+, ­) aligned?Are you using it under strong or fluorescent lighting?Check the cable connection with the other equipment. When using either INPUT1, INPUT4, INPUT5, or INPUT6 as the input source, confirm that the audio connectors have also been connected. [. . . ]