User manual PIONEER PDP-502MXE

[. . . ] Flush: Speakers are mounted flat against the sides of the display, and fixed in position (non-adjustable). Air: Speakers are mounted apart from the sides of the display, so as to allow adjustment of their angles. This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. [. . . ] Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. If you install the speakers flush /air, you cannot use the buttons on the right side of the display. See the Operating Instructions packed together with the stand for how to assemble the stand. Do not place force on the speakers' front panel grille net, or stick your finger or other object into the front of the speaker, since you may damage the grille net or speaker unit itself. When using the "Air" method of mounting speakers: if the speaker angle is changed, be sure to lock the speaker before use, to prevent it from moving. If the speaker is left in the movable position, personal injury could results by pinching fingers in the gap between speaker and display. 4 Adjust the position of the speaker and then fix the upper and lower screws firmly. Air mount (for adjustable-angle installation) Perform installation according to the following steps 1 to 2. Flush mount (for fixed-angle installation) Perform installation according to the following steps 1 to 2. 2 After pulling up the locking lever, change the speaker angle as desired, then push the locking lever down again. After connection to the terminals, pull lightly on the cable to confirm that the tips of the cable are properly connected to the terminals. An imperfect connection can cause sound interruptions and noise. When cable cores stick out and ª and · Lines are shortcircuited, an excessive load will be applied to the plasma display and the operation will stop or trouble will be caused. When the polarity is reversed for one speaker (left or right) at the time of connection to the plasma display, the bass reproduction will be reduced, the sound positioning will be lost, and a correct stereo effect will not be obtained. If you insert the speaker cord too far so that the insulation is touching the speaker terminal, you may not get any sound. Speed clamps are included with the plasma display for tidying your cables and keeping extra cable length out of the way. Use the supplied wiring clamp to hide the cables from view. Organize cables together using the speed clamps provided with the plasma display. Insert 1 into an appropriate hole on the rear of the unit, then snap 2 into the back of 1 to fix the clamp. [. . . ] Use the supplied wiring clamp to hide the cables from view. Organize cables together using the speed clamps provided with the plasma display. Insert 1 into an appropriate hole on the rear of the unit, then snap 2 into the back of 1 to fix the clamp. Use a polishing cloth or dry cloth to wipe off dust and dirt. [. . . ]