User manual PIONEER PDP-505SL

[. . . ] As the colours of the wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol , or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. NOTE After replacing or changing a fuse, the fuse cover in the plug must be replaced with a fuse cover which corresponds to the colour of the insert in the base of the plug or the word that is embossed on the base of the plug, and the appliance must not be used without a fuse cover. [. . . ] If you press 0 on the remote control unit, images come from the INPUT 1 source. if you press 1 to 9 , TV images display. You can also press POWER on the Plasma Display to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit or STANDBY/ON on the Plasma Display. If you are not going to use the Plasma Display System for a long period of time, be sure to remove the power cord from the power outlet. When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. You can check the current status of the system with the indicators on the Plasma Display. For other than the above, see "Troubleshooting" on page 43. Using P +/P ­ on the remote control unit P +/P ­ cannot pick up channels that are set to skip. Using 0 ­ 9 on the remote control unit When viewing Teletext information: View a page directly which is 3-digit page number from 100 to 899 by pressing buttons 0 to 9. In the standby mode, when you press 0, the power turns on and images come from the INPUT 1 source. Perform the following steps to before starting Auto Installation. Enter your 4-digit password using buttons 0 ­ 9. If no channel is found, check the antenna connections, and then retry Auto Installation. You can select from among "B/G", "D/K", "I", "L", and "L'". This function may not achieve a satisfactory result, depending on the conditions of broadcasting signals. When using a decoder with a decoder terminal selected, this function may fail to achieve a good result. You can select from among "Auto", "PAL", "SECAM", and "4. Child Lock inhibits selected TV channels from being tuned and watched. After selecting a channel (using Programme Entry), perform the following steps. You can select the channel using P +/P ­. Select this option to register the channel as your favourite channel. [. . . ] Pressing stops automatic subpage change and performs its respective button function. When receiving TOP Teletext, you can read a TOP text overview. 3 Press / and / to select the desired block or group When the TOP Over View screen is in display, no other buttons are available than i +/i ­, g, e, and a. In this case, operate the system after first turning off the power of the Plasma Display, or unplugging the power cord and re-plugging it in after 1 or 2 minutes. [. . . ]