User manual PIONEER PDP-5080XA

[. . . ] As the colours of the wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug, proceed as follows ; The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol , or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. NOTE After replacing or changing a fuse, the fuse cover in the plug must be replaced with a fuse cover which corresponds to the colour of the insert in the base of the plug or the word that is embossed on the base of the plug, and the appliance must not be used without a fuse cover. [. . . ] "ADV" is not selectable when PAL, SECAM, 576i, or 1080i@50Hz signals are input. Neither "Standard" nor "ADV" is selectable when 576p, 720p@50Hz, or 1080p@24Hz signals are input. To perform advanced picture adjustments, select "Pro Adjust" in step 3 and then press ENTER. To restore the factory defaults for all items, press / to select "Reset" in step 3, and then press ENTER. If you have selected a desired parameter in this step, skip steps 7 and 8. You may rather want to perform fine adjustment. To do this, select "Manual" first and then press and hold ENTER for more than three seconds. Selections High Mid-High Mid Mid-Low Low Manual White with bluish tone Intermediate tone between High and Mid Intermediate tone between Mid and Low White with reddish tone Colour temperature adjusted to your preference Fine adjustment For weaker red for bright For weaker green portions For weaker blue Fine adjustment For weaker red for dark For weaker green portions For weaker blue For stronger red For stronger green For stronger blue For stronger red For stronger green For stronger blue Closer to magenta Closer to red Closer to yellow Closer to green Closer to cyan Closer to blue Closer to yellow Closer to green Closer to cyan Closer to blue Closer to magenta Closer to red To perform adjustment for another item, press RETURN, and then repeat steps 7 and 8. To perform adjustment for another item, press RETURN, and then repeat steps 6 and 7. Eliminates video noise for clean crisp images. Eliminates mosquito noise from video images when a digital TV channel is watched or a DVD is played, resulting in noise-free images. This setting is not memorised by the system. Five minutes before the system is placed into the standby mode, a message appears every minute. The system will be automatically placed into the standby mode if no signal is received for 15 minutes. Does not place the system into the standby mode. Places the system into the standby mode if no signal is received for 15 minutes. Five minutes before the system is placed into the standby mode, a message appears every minute. The system may not be placed into the standby mode when noise signals are present at the Plasma Display after a TV programme finishes. Digital TV (DTV) not only replaces the conventional analogue TV channels, but also provides more channels, clearer picture quality, and various types of useful information. A channel banner shows programme names, start/end time of programmes and other channel information. When executing Auto Installation (page 24), make sure to select "Digital" or "All" as the tuner type. Selecting the DTV mode when no channels yet searched will only display "DTV Setup" screen with only the item "Installation" selectable. [. . . ] 3 Press / and / to select the desired block or group When the TOP Over View screen is in display, no other buttons are available than i +/i ­, g, e, and a. In this case, operate the system after first turning off the power of the Plasma Display, or unplugging the power cord and re-plugging it in after 1 or 2 minutes. Are batteries inserted with polarity (+, ­) aligned?Are you using it under strong or fluorescent lighting? [. . . ]