User manual PIONEER PDP-60MXE20

[. . . ] English This unit has been designed for use as a computer display monitor. The optional video card is required if you wish to view other video signals on the monitor. Thank you very much for purchasing this PIONEER product. Before using your Plasma Display, please read the "Safety Precautions" and these "Start up Guide" carefully so you will know how to operate the Plasma Display properly. [. . . ] As this unit is constructed with glass, be sure to install it on a flat, unwarped surface. When this unit is installed on a wall, the work should be done by a professional technician possessing the requisite technical knowledge and abilities; consult your dealer for more information. Main unit Center line a hole a hole 12 mm to 18 mm Bolt b hole b hole* a hole Center line a hole b hole* 12 mm to 14 mm a hole Bolt b hole* Connect the power cord after all component connections have been completed. Wind the audio cable (not supplied) around the ferrite core once, and then fasten the catch. If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards. Plug the power cord into a power outlet. 㷠For the Plasma Display, use a three-core power cord with a ground terminal. Always be sure to connect the power cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line. Do not use a power supply voltage other than that indicated (AC 100 V to 240 V, 50 Hz/60 Hz) as this may cause fire or electric shock. Use the provided cable tie to prevent the ferrite core from slipping on the cable. If you do not do this, this monitor will not conform to mandatory CE or C-Tick standards. To power outlet AC power cord Speed clamps are included with this unit for bunching cables together. Once components are connected, follow the following steps to route cables. Organize cables together using the provided speed clamps. Insert 1 into an appropriate hole on the rear of the unit, then snap 2 into the back of 1 to fix the clamp. Speed clamps are designed to be difficult to undo once in place. Bunch separated cables together and secure them with the provided bead bands. Do not allow excessive stress to be placed on the ends of cables. To attach the speed clamps to the main unit Use the holes marked with the & sign as needed. Connect the speed clamps using the 4 holes marked with "" below, depending on the situation. Using pliers, twist the clamp 90° and pull it outward. [. . . ] The display should be used within ambient temperature conditions below 40 °C. 3 The internal temperature has risen abnormally due to blocked cooling vents, overheating of internal electronic parts, or other factors. If the power is automatically turned off for a reason other than the above reasons, there could be a malfunction. In this case, unplug the power cord from the power outlet and request repair from your nearest sales outlet. [. . . ]