User manual PIONEER PDP-S09-LR

[. . . ] Flat countersunk head screw x 4 Hexagon socket head screw x 4 This product is designed exclusively for use with the PDP-4330HD, PDP-433HDE, PDP-433HDG Pioneer plasma display. In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: ÷ Do not supply power to the speaker system in excess of the maximum permissable input. When connecting or disconnecting pin-plugs, be sure that amplifier power is OFF. [. . . ] For top right side x 1 For top left side x 1 Flat countersunk head screw 1 The top side fittings are different for the right and the left side, and they must be matched correctly. 2 Install the mounting fittings with bolts at the positions shown in the figure on the left. When the display is to be moved after speaker installation, do not hold the display by the speakers. Hold the bottom of the display to move it. The grille nets are designed to protect the speakers, however excessive force (such as pushing on, or inserting objects between the grille nets) may result in damage. 1 Switch off the power of the plasma display. Install the unit marked "LEFT" on the left side of the display. Push the lever, insert the cable into the hole, and release the lever. Then, close tab firmly to secure the wire in place. 1 To attach the speakers to the display, start by placing the upper screw where indicated, tightening until there is a small space of about 5mm between the head of the screw and the display. 2 Check the rear of the speakers for the LEFT and RIGHT indicators to make sure you are attaching the correct speaker to the corresponding right or left side. Make sure the UP mark is pointing up, and then attach the speaker by fitting the upper mounting over the head of the screw and sliding down until snug. 3 Affix the lower fitting to the display and tighten the screw about halfway. 4 Adjust the position so that the gap between the speaker and the display is uniform, and then tighten the screws firmly. After connection to the terminals, pull lightly on the cable to confirm that the tips of the cable are properly connected to the terminals. An imperfect connection can cause sound interruptions and noise. [. . . ] Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. [. . . ]