User manual PIONEER PDP-S21-LR

[. . . ] In this case, lower the volume of the plasma display during use. After 5 to 10 seconds, the speakers are restored automatically. Placing a CRT computer screen or CRT monitor near to the speakers may result in interference or color distortion. If this happens, distance the monitor from the speakers. [. . . ] attach the left speaker in the same way. 1 Fix the upper screw temporarily in advance to hang the speaker on the display (In this case, leave a space of about 5 mm between the head of the screw and the display). 4 Adjust the position so that the speaker is parallel to the display and then fix the upper and lower screws firmly. Separate the 3 cushions evenly, making sure you don't cover the screws with the speaker cushions when placing them. Take care to ensure that the display does not hit the speakers in steps 1 and 2 when speakers are installed on the display. 1 Place it below the display while inclining one speaker and insert it into the bracket on the right side. When attaching the speakers to the plasma display, make sure to tighten all the screws, making sure the speakers are secure and do not shake. When the display is to be moved after speaker installation, do not hold the display by the speakers. Hold the handle of the display and the side or bottom of the display with reference to the figures below when moving the speaker system. Do not hold the speakers and raise the display. 2 Similarly, insert the other speaker into the bracket on the left side. 3 Adjust so that the clearance between the speakers is lost and so that the speakers are not shifted to the right or left. When the speakers are installed on the right and left sides When the speakers are installed at the bottom Make sure not to push on the speaker cover with force, using your fingers or otherwise. The speaker cover can be broken, and damage to the speaker unit may also occur as a result. 4 Fix the two points in the center of the display with screws. 1 Switch off the power of the plasma display. Push the lever, insert the cable into the hole, and release the lever. 5 Fix the two points on the right and left sides with screws. Adjust so that the speaker system is parallel to the display and then finish securing the screws you had lightly tightened on the mounting fittings. Make sure the speaker is fit snug against the bracket, then tighten the screws. [. . . ] Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. When a chemical cloth is used, read the cautions for the chemical cloth carefully. Speed clamps are designed to be difficult to undo once in place. Using pliers, twist the clamp 90° and pull it outward. [. . . ]