User manual PIONEER PDP-S23-LR

[. . . ] If this happens, distance the monitor from the speakers. 7 Speaker mounting fittings (used when mounting the speaker so as to allow angle adjustment) When screws other than those enclosed as accessories are used to install the speakers, the speakers may drop off or accidents may be caused. always use the screws enclosed as accessories. Speakers are designed to allow the two methods of installation shown, in accordance with the user's preference: 1. [. . . ] Flush mount (for fixed-angle installation) Perform installation according to the following steps 1 to 2. 2 Attach another bracket (RIGHT) to the bottom of the speaker in the same way. The locking screw is located in the bottom side of the speaker only. The right and left lower speaker brackets are pre-applied with twosided tape to prevent the lower covers from dropping. Remove the protective paper from the tape before fixing the covers in place. The illustration below shows how to attach of the right speaker. attach the left speaker in the same way. 1 Fix the upper screw temporarily in advance to hang the speaker on the display (In this case, leave a space of about 5 mm between the head of the screw and the display). The illustration below shows how to attach of the right speaker. attach the left speaker in the same way. 1 Fix the upper screw temporarily in advance to hang the speaker on the display (In this case, leave a space of about 5 mm between the head of the screw and the display). When the display is to be moved after speaker installation, do not hold the display by the speakers. Hold the display with one hand on the bottom of the unit and the other on the handle on the rear. Do not hold the speakers and raise the display. 4 Adjust the position of the speaker and then fix the upper and lower screws firmly. 1 Switch off the power of the plasma display. Push the lever, insert the cable into the hole, and release the lever. 5 Secure the cable with the cable clip as shown, then press the remaining speaker cable into the groove (in the lower cover). White with gray line White For the output terminals on the plasma display, push the lever, insert the cable into the hole, and release the lever. 2 After pulling up the locking lever, change the speaker angle as desired, then push the locking lever down again. [. . . ] When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. When a chemical cloth is used, read the cautions for the chemical cloth carefully. Speed clamps are designed to be difficult to undo once in place. [. . . ]