User manual PIONEER PDP-S24-LR

[. . . ] Please handle the speaker with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. Placing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. If this happens, distance the monitor from the speaker. about the input · In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: · Do not connect these speakers to anything other than the specified flat screen TV. [. . . ] Be sure to turn the connected devices off and remove the power cord from the wall outlet beforehand when changing the connection or installation method. When using a tone control function to greatly emphasize treble sounds, do not use excessive amplifier volume. Consult your dealer if you encounter any difficulties with this installation. Pioneer is not liable for any damage resulting from improper installation, improper use, modification, or natural disasters. There are top and bottom speaker brackets for both the left and the right speaker. Attach the appropriate brackets to the top and the bottom on the back of the speakers using the supplied screws. Screw an supplied screw into the speaker mounting hole (lower of the two) at the top, rear of the flat screen TV. Leave it loose, with about 5 mm left to tighten. Adjust the position of the speaker and then tighten the upper and lower screws firmly. Connect the other cables and power cord to the flat screen TV. NOTE: Avoid pinching or creating pressure points when routing or bundling cables. to remove the clamp band , pull and hold the latch to release. To remove the cable clamp, push and hold the levers then pull it out from the hole. For details, refer to the operating instructions supplied with the hung on wall unit. caution Do not lift up the flat screen TV by the speakers. A speakers may come off, so hold it by the bottom. NOTE: The longer a clamp is in place, the better chance of deterioration. An older clamp is more easily damaged while being removed and may not be reusable. [. . . ] An older clamp is more easily damaged while being removed and may not be reusable. Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. [. . . ]