User manual PIONEER PDP-S26-LR

[. . . ] This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. After installation, be sure to deliver this manual to the customer and explain to the customer how to handle the product. [. . . ] aUDIO (OUTPUT) (Stereo mini jack) Use to output the audio of the selected source component connected to this unit to an AV amplifier or similar component. Note: No sound is produced from the AUDIO (OUTPUT) jack when the MAIN POWER switch is set to OFF or ON (standby). Use to obtain sound when INPUT1 is selected. Note: The video signal will not be output from the ANALOG RGB OUT (INPUT1) terminal when the main power of this unit is off or in standby mode. Make sure that the connection made corresponds to the format of the signal output from the connected component. MAIN POWER switch Use to switch the main power of the unit on and off. Never connect any component to these connectors without first consulting your Pioneer installation technician. These connectors are used for Plasma Display setup adjustments. RS-232C Never connect any component to this connector without first consulting your Pioneer installation technician. This connector is used for Plasma Display setup adjustments. aUDIO (OUTPUT) (Stereo mini jack) Use to output the audio of the selected source component connected to this unit to an AV amplifier or similar component. Using pliers, twist the clamp 90° and pull it outward. In some cases the clamp may have deteriorated over time and may get damaged when removed. The onscreen display language has been set to English as the factory default. To change to another language, the screen setting must be changed. Follow the procedures below to change the setting. Use the 5/ buttons to select [LANGUAGE], then press the SET button. The STANDBY/ON indicator on the front panel will light red. Press the STANDBY/ON button to turn the power ON. The STANDBY/ON indicator on the front panel will light green. Each time the 2/3 buttons are pressed, the language alternates between those available, in the following order: With the desired language displayed, press the SET button. The selected language will be set in memory, and the screen will return to that shown in step 4. [. . . ] Except in cases where violation of intellectual property rights may be involved, it is recommended that lag-image burning be avoided by selecting a screen size that displays images over the entire screen. ⷠIn addition, the [ORBITER] function and [ENERGY SAVE] function can also be used to reduce the chance of lag image formation. When the display is used for long periods of time, some parts of the display may retain heat and the display may become hot to the touch; this is normal and not a malfunction. If the power is automatically turned off during operation of this unit, the following reasons may be the cause. [. . . ]